Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green rectangular DDR3 DIMM with black chips on both sides, 240 gold pins along bottom edge

A-Tech

A-Tech Supermicro Certified 4GB DDR3 1600 CL11 1.5V 240-Pin DIMM

SKU CH-84RV-WG1YD

A 4 GB DDR3 1600 CL11 DIMM certified for Supermicro systems, running at 1.5 V with 240 pins and Hynix chips

  • Capacity4GB
  • SpeedDDR3 1600 (PC3 12800)
  • Tested Frequency1600
  • CAS LatencyCL11
  • Voltage1.50V
  • ECCNo
  • Supermicro certified for guaranteed system compatibility
  • 4GB DDR3 1600MHz boosts multitasking responsiveness
  • CL11 latency at 1.5V standard voltage
  • 240-pin unbuffered DIMM fits desktop slots
  • Hynix chips tested for reliable operation

Supermicro Certified DDR3 1600 Module

This 4 GB DDR3 1600 DIMM carries Supermicro certification and runs at the standard 1.5 V JEDEC voltage. It is built with Hynix chips in a single-rank 2Rx8 layout and uses an unbuffered non-ECC design for desktop platforms. The 240-pin form factor fits the DDR3 slots found on qualified Supermicro systems.

Suited for Supermicro desktop upgrades

The module targets owners of compatible Supermicro workstations or servers that specify PC3-12800 unbuffered memory. It is not intended for platforms that require registered or ECC DIMMs, nor for boards limited to lower DDR3 speeds. Buyers should confirm their system's qualified-vendor list before ordering.

Certified compatibility replaces guesswork

Supermicro validation means the stick has passed the vendor's own qualification suite, reducing the risk of POST failures or timing mismatches. No heat spreader is included, so airflow in dense chassis remains unimpeded. The package contains only the memory module itself.

Kohokohdat

  • Supermicro certified for guaranteed system compatibility
  • 4GB DDR3 1600MHz boosts multitasking responsiveness
  • CL11 latency at 1.5V standard voltage
  • 240-pin unbuffered DIMM fits desktop slots
  • Hynix chips tested for reliable operation

Tekniset tiedot

BrandSuperMicro
SeriesSupermicro Certified
ModelMEM-DR340L-HL01-UN16
Capacity4GB
SpeedDDR3 1600 (PC3 12800)
Tested Frequency1600
CAS LatencyCL11
Voltage1.50V
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor Brand Chipset
Heat SpreaderNo
FeaturesSupermicro Certified MEM-DR340L-HL01-UN16 (Hynix)
Recommend UseCompatible Supermicro Systems

Kysymyksiä tästä tuotteesta

Does my motherboard need to support DDR3 1600 PC3-12800 1.5V unbuffered non-ECC 240-pin DIMMs for this module to work?

Yes, the board must accept DDR3 1600 PC3-12800 1.5V unbuffered non-ECC 240-pin DIMMs; check your system manual for the supported memory list before purchase.

Can I mix this 1600 MHz CL11 module with slower DDR3 DIMMs already in my system?

The module will run at the speed of the slowest installed DIMM; mixing with lower-speed DDR3 is possible but overall memory frequency will drop to the lowest common setting.

How can I confirm the stick is running at 1600 MHz CL11 after installation?

Check the memory frequency and timings in BIOS or a system-information utility; they should report 1600 MHz and CL11 when the module is operating as specified.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.