Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Two green DDR4 DIMM sticks without heat spreaders

Computer Memory Solutions

Computer Memory Solutions CM1024722400ECCR 16GB (2x8GB) DDR4 2400 ECC Registered DIMM memory upgrade

SKU CH-9PC8-394HZ

16 GB (2 × 8 GB) DDR4 2400 ECC registered DIMM kit for ASRock D1540D4I, Fatal1ty X99X Killer, Fatal1ty X99X Killer/3.1 and X99 Extreme11

  • Capacity16GB (2 x 8GB)
  • Type288-Pin DDR4 SDRAM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Timing17-17-17
  • Voltage1.2V
  • ECC protection prevents data corruption in critical workloads
  • Registered buffering improves signal integrity on eight-slot boards
  • 2400 MHz speed matches X99 platform specifications
  • 16 GB dual-channel kit enables 128 GB maximum capacity
  • Guaranteed compatibility with four ASRock X99 motherboards

Compatible DDR4 ECC Registered Kit

This 16 GB kit contains two 8 GB DDR4 2400 registered DIMMs built for ASRock D1540D4I, Fatal1ty X99X Killer, Fatal1ty X99X Killer/3.1 and X99 Extreme11 motherboards. It targets administrators who need error-correcting memory on these specific platforms.

Two-Module Packaging and Verified Compatibility

The bundle supplies a matched pair so both channels can be populated at once. Computer Memory Solutions validates each kit against the listed boards, removing the guesswork that comes with mixing generic modules on registered platforms.

DDR4 2400 Registered Constraints

Registered DIMMs require a memory controller that supports buffering; consumer chipsets will not recognise them. The modules operate at 1.2 V and CL17, and the board will clock them down if the installed processor cannot sustain 2400 MT/s. Builders needing unbuffered memory or higher speeds must choose a different product.

Põhijooned

  • ECC protection prevents data corruption in critical workloads
  • Registered buffering improves signal integrity on eight-slot boards
  • 2400 MHz speed matches X99 platform specifications
  • 16 GB dual-channel kit enables 128 GB maximum capacity
  • Guaranteed compatibility with four ASRock X99 motherboards

Tehnilised andmed

BrandComputer Memory Solutions
ModelCM1024722400ECCR
Capacity16GB (2 x 8GB)
Type288-Pin DDR4 SDRAM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Timing17-17-17
Voltage1.2V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemASRock Motherboard D1540D4I, Fatal1ty X99X Killer, Fatal1ty X99X Killer/3.1, X99 Extreme11
Package Content2 Memory RAM Sticks

Küsimused selle toote kohta

Will the ECC registered DIMMs need any firmware updates or periodic replacement after installation?

ECC registered DIMMs have no moving parts or firmware to update. They run at 1.2 V with CL17 timing and do not require scheduled replacement.

What limit appears first when the kit runs at DDR4 2400 continuously?

The memory controller on the ASRock X99 or D1540D4I board will reach its maximum supported frequency of DDR4 2400 before the modules hit any thermal or voltage ceiling.

How much heat and noise do the two 8 GB sticks produce during all-day operation?

With no heat spreader and a low 1.2 V operating voltage, the modules generate minimal heat and add no audible noise to the system.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.