Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Two green DDR4 DIMM sticks without heat spreaders

Computer Memory Solutions

Computer Memory Solutions CM1024722400ECCR 16GB (2x8GB) DDR4 2400 ECC Registered DIMM memory upgrade

SKU CH-9PC8-394HZ

16 GB (2 × 8 GB) DDR4 2400 ECC registered DIMM kit for ASRock D1540D4I, Fatal1ty X99X Killer, Fatal1ty X99X Killer/3.1 and X99 Extreme11

  • Capacity16GB (2 x 8GB)
  • Type288-Pin DDR4 SDRAM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Timing17-17-17
  • Voltage1.2V
  • ECC protection prevents data corruption in critical workloads
  • Registered buffering improves signal integrity on eight-slot boards
  • 2400 MHz speed matches X99 platform specifications
  • 16 GB dual-channel kit enables 128 GB maximum capacity
  • Guaranteed compatibility with four ASRock X99 motherboards

Compatible DDR4 ECC Registered Kit

This 16 GB kit contains two 8 GB DDR4 2400 registered DIMMs built for ASRock D1540D4I, Fatal1ty X99X Killer, Fatal1ty X99X Killer/3.1 and X99 Extreme11 motherboards. It targets administrators who need error-correcting memory on these specific platforms.

Two-Module Packaging and Verified Compatibility

The bundle supplies a matched pair so both channels can be populated at once. Computer Memory Solutions validates each kit against the listed boards, removing the guesswork that comes with mixing generic modules on registered platforms.

DDR4 2400 Registered Constraints

Registered DIMMs require a memory controller that supports buffering; consumer chipsets will not recognise them. The modules operate at 1.2 V and CL17, and the board will clock them down if the installed processor cannot sustain 2400 MT/s. Builders needing unbuffered memory or higher speeds must choose a different product.

Istaknuto

  • ECC protection prevents data corruption in critical workloads
  • Registered buffering improves signal integrity on eight-slot boards
  • 2400 MHz speed matches X99 platform specifications
  • 16 GB dual-channel kit enables 128 GB maximum capacity
  • Guaranteed compatibility with four ASRock X99 motherboards

Specifikacije

BrandComputer Memory Solutions
ModelCM1024722400ECCR
Capacity16GB (2 x 8GB)
Type288-Pin DDR4 SDRAM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Timing17-17-17
Voltage1.2V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemASRock Motherboard D1540D4I, Fatal1ty X99X Killer, Fatal1ty X99X Killer/3.1, X99 Extreme11
Package Content2 Memory RAM Sticks

Pitanja o ovom artiklu

Will the ECC registered DIMMs need any firmware updates or periodic replacement after installation?

ECC registered DIMMs have no moving parts or firmware to update. They run at 1.2 V with CL17 timing and do not require scheduled replacement.

What limit appears first when the kit runs at DDR4 2400 continuously?

The memory controller on the ASRock X99 or D1540D4I board will reach its maximum supported frequency of DDR4 2400 before the modules hit any thermal or voltage ceiling.

How much heat and noise do the two 8 GB sticks produce during all-day operation?

With no heat spreader and a low 1.2 V operating voltage, the modules generate minimal heat and add no audible noise to the system.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.