Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Silver 3.5-inch internal hard drive with SAS connector and green circuit board

DELL

DELL MY58D 3TB SAS 7.2K 3.5" internal hard drive

SKU CH-KK0H-Z31A0

3TB SAS desktop drive spins at 7200 RPM with a 6 Gbps interface for reliable bulk storage

  • 3 TB capacity stores large datasets
  • SAS 6 Gbit/s interface enables fast data transfers
  • 7 200 RPM spindle speed delivers responsive performance
  • 5-inch form factor fits standard drive bays
  • Tested unit verified for reliable operation

Dell MY58D 3 TB SAS drive

This 3.5-inch hard drive offers 3 TB of storage over a 6 Gbit/s SAS interface at 7200 RPM. It is built for desktop workstations or entry-level servers that need reliable bulk capacity rather than peak throughput. The drive ships new and has been tested for basic operation. Its standard 3.5-inch form factor fits typical internal bays.

Who this suits and who should look elsewhere

The drive suits system builders adding a single high-capacity spindle to a SAS backplane or RAID controller. It is not for buyers who need the lower latency of solid-state storage or the simpler cabling of native SATA drives without a SAS controller. Systems limited to SATA-only ports cannot use this unit without an adapter. Laptop or small-form-factor chassis lacking a 3.5-inch bay are also incompatible.

Installation notes and common pitfalls

Mount the drive in a 3.5-inch bay using four standard screws and connect both the SAS data and power cables. The SAS connector is keyed differently from SATA, so verify the controller port before forcing the plug. A frequent issue is the drive not appearing in BIOS because the SAS controller BIOS or HBA firmware is disabled or outdated. Another common error is using a SATA-only backplane, which will not pass SAS signals.

Põhijooned

  • 3 TB capacity stores large datasets
  • SAS 6 Gbit/s interface enables fast data transfers
  • 7 200 RPM spindle speed delivers responsive performance
  • 5-inch form factor fits standard drive bays
  • Tested unit verified for reliable operation

Tehnilised andmed

Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.

Küsimused selle toote kohta

Does my motherboard or controller need a SAS port for this MY58D drive to work?

Yes, the MY58D uses a SAS interface at 6 Gb/s, so a SAS HBA or RAID card with a free port and matching cable is required.

Can I run this 3 TB SAS drive on the same controller as my older SATA drives?

A SAS controller will recognise both SAS and SATA drives, letting the MY58D share the same backplane or cable chain as legacy SATA disks.

How can I verify the MY58D is running at its rated 7200 RPM after installation?

Check the drive’s reported rotation speed in SMART data or the controller BIOS; it should read 7200 RPM for the HUS724030ALS640 mechanism.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.