Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Silver 3.5-inch internal hard drive with SAS connector and green circuit board

DELL

DELL MY58D 3TB SAS 7.2K 3.5" internal hard drive

SKU CH-KK0H-Z31A0

3TB SAS desktop drive spins at 7200 RPM with a 6 Gbps interface for reliable bulk storage

  • 3 TB capacity stores large datasets
  • SAS 6 Gbit/s interface enables fast data transfers
  • 7 200 RPM spindle speed delivers responsive performance
  • 5-inch form factor fits standard drive bays
  • Tested unit verified for reliable operation

Dell MY58D 3 TB SAS drive

This 3.5-inch hard drive offers 3 TB of storage over a 6 Gbit/s SAS interface at 7200 RPM. It is built for desktop workstations or entry-level servers that need reliable bulk capacity rather than peak throughput. The drive ships new and has been tested for basic operation. Its standard 3.5-inch form factor fits typical internal bays.

Who this suits and who should look elsewhere

The drive suits system builders adding a single high-capacity spindle to a SAS backplane or RAID controller. It is not for buyers who need the lower latency of solid-state storage or the simpler cabling of native SATA drives without a SAS controller. Systems limited to SATA-only ports cannot use this unit without an adapter. Laptop or small-form-factor chassis lacking a 3.5-inch bay are also incompatible.

Installation notes and common pitfalls

Mount the drive in a 3.5-inch bay using four standard screws and connect both the SAS data and power cables. The SAS connector is keyed differently from SATA, so verify the controller port before forcing the plug. A frequent issue is the drive not appearing in BIOS because the SAS controller BIOS or HBA firmware is disabled or outdated. Another common error is using a SATA-only backplane, which will not pass SAS signals.

Přednosti

  • 3 TB capacity stores large datasets
  • SAS 6 Gbit/s interface enables fast data transfers
  • 7 200 RPM spindle speed delivers responsive performance
  • 5-inch form factor fits standard drive bays
  • Tested unit verified for reliable operation

Specifikace

Pro tento produkt zatím nejsou zveřejněny žádné specifikace.

Otázky k tomuto produktu

Does my motherboard or controller need a SAS port for this MY58D drive to work?

Yes, the MY58D uses a SAS interface at 6 Gb/s, so a SAS HBA or RAID card with a free port and matching cable is required.

Can I run this 3 TB SAS drive on the same controller as my older SATA drives?

A SAS controller will recognise both SAS and SATA drives, letting the MY58D share the same backplane or cable chain as legacy SATA disks.

How can I verify the MY58D is running at its rated 7200 RPM after installation?

Check the drive’s reported rotation speed in SMART data or the controller BIOS; it should read 7200 RPM for the HUS724030ALS640 mechanism.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.