Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Aqua blue duplex fibre cable with SC connectors on both ends, 20m length

Enfain

Enfain OM3 SC-SC Duplex Multimode Fibre Optic Cable 20m

SKU CH-0P0M-64D5P

A 20 metre OM3 duplex patch cable with SC connectors, 3.0 mm jacket and 850 nm wavelength for 10 Gbit links

Length 20m

  • OM3 core supports 10 Gbps links up to 20 metres
  • Typical insertion loss of .2 dB preserves signal strength
  • Return loss above 38 dB cuts reflected light
  • 0 mm PVC jacket withstands 1000 mating cycles
  • Operates reliably from -20 °C to 60 °C

Enfain OM3 SC-SC Duplex Fibre Cable

This Enfain OM3 multimode fibre patch cable uses SC connectors on both ends. The duplex construction carries two fibres for simultaneous transmit and receive paths. It is built for 10G gigabit links at an 850nm wavelength. The aqua blue 3.0mm PVC jacket protects the ceramic ferrules inside.

Suits 10G links in racks and patch panels

Installers running 1G, 10G or 40G multimode connections between switches, servers or data centre equipment will find this cable matches the spec. It is not for single-mode infrastructure. Buyers who need LC, ST or MTP connectors must choose a different cable. The fixed 20m length cannot be shortened or extended.

Verify SC ports and multimode optics

Confirm that both devices present SC receptacles and support multimode transmission at 850nm. Check that the planned route respects the 330mm minimum bending radius. The operating range spans -20°C to +60°C. Typical insertion loss is .2dB with a maximum of .3dB and return loss exceeds 38dB.

Põhijooned

  • OM3 core supports 10 Gbps links up to 20 metres
  • Typical insertion loss of .2 dB preserves signal strength
  • Return loss above 38 dB cuts reflected light
  • 0 mm PVC jacket withstands 1000 mating cycles
  • Operates reliably from -20 °C to 60 °C

Tehnilised andmed

Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.

Selle mudeli teised versioonid

5 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

Which SC ports on my switch or server must be free to plug in this 20 m OM3 duplex cable?

You need two free SC sockets — one for each end of the duplex pair — on the switch, server or patch panel you are connecting.

Will the 3.0 mm jacket and 850 nm OM3 core work with the OM2 patch cords already in my rack?

Yes — the cable is OM3 10-gigabit multimode at 850 nm, so it interoperates with OM2 links; the combined link will simply run at the lower OM2 bandwidth.

How can I verify the link is performing to spec after I connect the cable?

Measure insertion loss with a light source and power meter at 850 nm; a reading at or below .3 dB confirms the cable meets its maximum insertion-loss spec.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.