Kripto para kabul ediyoruz — böylece elinizdeki koinlerle gerçek donanım alabilirsiniz.Kripto parayla ödeyin, onu gerçek donanıma harcayın. $399 üzeri siparişlerde dünya genelinde sigortalı kargo ücretsizdir. Sade, markasız koliler Almanya’dan gönderilir.$399 üzeri siparişlerde sigortalı kargo ücretsizdir. Ödeme sayfası açıldığında kurunuz 30 dakika kilitli kalır.Kur 30 dakika kilitli. Her ürün mühürlüdür, seri numarası kontrol edilir ve 24 ay garanti kapsamındadır.Mühürlü, 24 ay garantili.

Favori ürünler Giriş yap

Enfain

Enfain OM3 SC-SC Duplex Multimode Fibre Optic Cable 20m

SKU CH-0P0M-64D5P

A 20 metre OM3 duplex patch cable with SC connectors, 3.0 mm jacket and 850 nm wavelength for 10 Gbit links

Length 20m

  • OM3 core supports 10 Gbps links up to 20 metres
  • Typical insertion loss of .2 dB preserves signal strength
  • Return loss above 38 dB cuts reflected light
  • 0 mm PVC jacket withstands 1000 mating cycles
  • Operates reliably from -20 °C to 60 °C

Enfain OM3 SC-SC Duplex Fibre Cable

This Enfain OM3 multimode fibre patch cable uses SC connectors on both ends. The duplex construction carries two fibres for simultaneous transmit and receive paths. It is built for 10G gigabit links at an 850nm wavelength. The aqua blue 3.0mm PVC jacket protects the ceramic ferrules inside.

Suits 10G links in racks and patch panels

Installers running 1G, 10G or 40G multimode connections between switches, servers or data centre equipment will find this cable matches the spec. It is not for single-mode infrastructure. Buyers who need LC, ST or MTP connectors must choose a different cable. The fixed 20m length cannot be shortened or extended.

Verify SC ports and multimode optics

Confirm that both devices present SC receptacles and support multimode transmission at 850nm. Check that the planned route respects the 330mm minimum bending radius. The operating range spans -20°C to +60°C. Typical insertion loss is .2dB with a maximum of .3dB and return loss exceeds 38dB.

Öne çıkanlar

  • OM3 core supports 10 Gbps links up to 20 metres
  • Typical insertion loss of .2 dB preserves signal strength
  • Return loss above 38 dB cuts reflected light
  • 0 mm PVC jacket withstands 1000 mating cycles
  • Operates reliably from -20 °C to 60 °C

Teknik özellikler

Bu ürün için henüz yayınlanmış teknik özellik yok.

Bu modelin diğer sürümleri

Aynı seriden 5 tane daha

Aynı aile, farklı bellek, soğutucu veya frekans — karar vermeden önce karşılaştırın.

Bu ürünle ilgili sorular

Which SC ports on my switch or server must be free to plug in this 20 m OM3 duplex cable?

You need two free SC sockets — one for each end of the duplex pair — on the switch, server or patch panel you are connecting.

Will the 3.0 mm jacket and 850 nm OM3 core work with the OM2 patch cords already in my rack?

Yes — the cable is OM3 10-gigabit multimode at 850 nm, so it interoperates with OM2 links; the combined link will simply run at the lower OM2 bandwidth.

How can I verify the link is performing to spec after I connect the cable?

Measure insertion loss with a light source and power meter at 850 nm; a reading at or below .3 dB confirms the cable meets its maximum insertion-loss spec.

Bu reyondan diğerleri

Müşteriler bunları karşılaştırdı

Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.