Epoch
Epoch 400-BLLE 6T6TD 8TB 7200RPM SATA 3.5" Internal Hard Drive Replacement Kit
An 8 TB, 7200 RPM SATA hard drive in a 3.5-inch form factor supplied as a replacement kit for Dell PowerEdge 14 and 15 generation servers
- InterfaceSATA
- Capacity8TB
- RPM7200 RPM
- UsageIdeal for Servers
- Form Factor3.5"
- 8 TB capacity stores large server datasets
- 7200 RPM spindle delivers fast sequential throughput
- SATA 6 Gb/s interface fits existing backplanes
- 5 inch form factor matches standard drive bays
- Validated across 14 G and 15 G Dell PowerEdge servers
Purpose-Built Server Storage
The Epoch 400-BLLE 6T6TD is an 8 TB 3.5-inch SATA hard drive rotating at 7200 RPM. It ships as a replacement kit validated for Dell PowerEdge 14 and 15 Generation rack and tower servers. Enterprise buyers receive a drive tested for continuous operation in multi-bay arrays.
Compatibility Scope
This kit suits administrators expanding or repairing the listed Dell PowerEdge R and T series platforms. Environments that require a different interface, a smaller form factor, or a lower spindle speed should select an alternative drive.
Decisive Specification
The 7200 RPM spindle speed determines sustained transfer rates for sequential workloads. Verify that the target server bay accepts a 3.5-inch SATA device before ordering.
Põhijooned
- 8 TB capacity stores large server datasets
- 7200 RPM spindle delivers fast sequential throughput
- SATA 6 Gb/s interface fits existing backplanes
- 5 inch form factor matches standard drive bays
- Validated across 14 G and 15 G Dell PowerEdge servers
Tehnilised andmed
| Interface | SATA |
|---|---|
| Capacity | 8TB |
| RPM | 7200 RPM |
| Usage | Ideal for Servers |
| Form Factor | 3.5" |
Küsimused selle toote kohta
Does the 3.5" drive fit the standard drive bays in Dell PowerEdge 14G and 15G servers?
Yes, the 3.5-inch form factor matches the hot-swap bays in the listed PowerEdge 14G and 15G rack and tower models.
What installation step is often missed when adding this SATA drive to a Dell server?
The drive must be seated in the supplied carrier so the SATA connector aligns with the backplane; inserting the bare drive without the carrier will not connect.
When should the 8TB 7200RPM drive be replaced in a server running continuous workloads?
Plan replacement after the manufacturer-rated service life or at the first sign of SMART reallocated-sector growth to avoid array degradation.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
