Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Rectangular silver server power supply module with rear connector and handle

godream

godream DPS-550AB-11 A PS-2550-5L for NF5270M4 Server Power Redundant Module power supply

SKU CH-KW5M-XP7BE

550W ATX redundant power module for NF5270M4 server systems

  • TypeATX
  • Redundant module keeps NF5270M4 servers running during power-supply failure
  • 550 W output capacity meets NF5270M4 power requirements
  • Hot-swap design enables replacement without server downtime
  • ATX form factor fits standard NF5270M4 power bays

NF5270M4 server redundant power module

The godream DPS-550AB-11 A PS-2550-5L is a 550 watt ATX-type redundant power supply built for the NF5270M4 server platform. It slides into the chassis as a hot-swap module so that a second unit can take over instantly if the first fails. This design targets operators who need continuous uptime without shutting down the rack to replace a faulty unit. It is not suited for desktop ATX cases or single-supply workstations.

Thermals noise and power draw

Redundant sharing splits the load between two modules so each runs at lower utilisation, keeping internal temperatures moderate under typical server workloads. Fan speed ramps with demand, so idle noise stays low while full-load airflow meets the 550 watt rating. The ATX form factor routes exhaust through the rear of the module, matching the NF5270M4 airflow path. No external power brick or additional cabling is required beyond the standard server backplane connection.

Põhijooned

  • Redundant module keeps NF5270M4 servers running during power-supply failure
  • 550 W output capacity meets NF5270M4 power requirements
  • Hot-swap design enables replacement without server downtime
  • ATX form factor fits standard NF5270M4 power bays

Tehnilised andmed

TypeATX

Küsimused selle toote kohta

How do I install the DPS-550AB-11 into the NF5270M4 server chassis?

Slide the module into the redundant power bay until the latch clicks; the step most people miss is fully seating the edge connector so the 550 W unit registers as active.

What maintenance will the DPS-550AB-11 need during its service life?

Clean the intake vents quarterly and replace the internal fan if bearing noise appears; the 11-series design uses a single hot-swap fan that can be swapped without tools.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.