Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Rectangular silver server power supply module with rear connector and handle

godream

godream DPS-550AB-11 A PS-2550-5L for NF5270M4 Server Power Redundant Module power supply

SKU CH-KW5M-XP7BE

550W ATX redundant power module for NF5270M4 server systems

  • TypeATX
  • Redundant module keeps NF5270M4 servers running during power-supply failure
  • 550 W output capacity meets NF5270M4 power requirements
  • Hot-swap design enables replacement without server downtime
  • ATX form factor fits standard NF5270M4 power bays

NF5270M4 server redundant power module

The godream DPS-550AB-11 A PS-2550-5L is a 550 watt ATX-type redundant power supply built for the NF5270M4 server platform. It slides into the chassis as a hot-swap module so that a second unit can take over instantly if the first fails. This design targets operators who need continuous uptime without shutting down the rack to replace a faulty unit. It is not suited for desktop ATX cases or single-supply workstations.

Thermals noise and power draw

Redundant sharing splits the load between two modules so each runs at lower utilisation, keeping internal temperatures moderate under typical server workloads. Fan speed ramps with demand, so idle noise stays low while full-load airflow meets the 550 watt rating. The ATX form factor routes exhaust through the rear of the module, matching the NF5270M4 airflow path. No external power brick or additional cabling is required beyond the standard server backplane connection.

Helstu kostir

  • Redundant module keeps NF5270M4 servers running during power-supply failure
  • 550 W output capacity meets NF5270M4 power requirements
  • Hot-swap design enables replacement without server downtime
  • ATX form factor fits standard NF5270M4 power bays

Tæknilýsing

TypeATX

Spurningar um þessa vöru

How do I install the DPS-550AB-11 into the NF5270M4 server chassis?

Slide the module into the redundant power bay until the latch clicks; the step most people miss is fully seating the edge connector so the 550 W unit registers as active.

What maintenance will the DPS-550AB-11 need during its service life?

Clean the intake vents quarterly and replace the internal fan if bearing noise appears; the 11-series design uses a single hot-swap fan that can be swapped without tools.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.