Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Green printed circuit board with black memory chips and gold edge connectors

NEMIX RAM

NEMIX RAM 16GB DDR5 4800 CL40 1Rx8 ECC RDIMM Supermicro H13SSW memory upgrade

SKU CH-1SG7-A6NHJ

16 GB DDR5 4800 CL40 ECC registered RDIMM validated for Supermicro H13SSW servers

  • Capacity16GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 16GB

Näita veel 24 konfiguratsiooni
  • Registered ECC protects data integrity
  • DDR5-4800 speed matches server spec
  • 1Rx8 rank works fully populated
  • 1V voltage meets platform requirement
  • 288-pin RDIMM fits Supermicro H13SSW

Supermicro H13SSW DDR5 upgrade

This 16 GB DDR5 4800 registered ECC RDIMM is built to the exact rank, voltage and timing the Supermicro H13SSW motherboard expects. It installs as a single 288-pin module so the server recognises full capacity at rated speed.

Replacing slower or smaller DDR5 DIMMs

Swapping older DDR5 modules for this CL40 1.10 V part adds 16 GB per slot while keeping registered buffering and ECC active across every populated channel. The jump is worth it when your workload needs maximum registered-DIMM capacity without mixing ranks or voltages.

DDR5 registered DIMM limits

DDR5 RDIMMs require a motherboard that supports registered signalling and the correct population order; UDIMM or SODIMM slots will not accept the 288-pin form factor. Always verify the system manual for approved capacities and slot sequence before installation.

Põhijooned

  • Registered ECC protects data integrity
  • DDR5-4800 speed matches server spec
  • 1Rx8 rank works fully populated
  • 1V voltage meets platform requirement
  • 288-pin RDIMM fits Supermicro H13SSW

Tehnilised andmed

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-618K1
Capacity16GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content16GB DDR5 4800MHz PC5-38400 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Selle mudeli teised versioonid

5 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

Does the 288-pin DDR5 RDIMM fit the Supermicro H13SSW motherboard slots?

Yes, the module is a 288-pin DDR5 RDIMM, which matches the form factor and registered architecture required by the H13SSW motherboard.

What is the correct installation step for the 1Rx8 registered ECC module on this board?

Power down the server, open the chassis, align the module's key notch with the DDR5 slot, press firmly until the ejector clips lock, then follow the motherboard manual's population order for registered DIMMs.

Will the 1.1V DDR5 module require any firmware update or replacement over time?

The module operates at the standard 1.1V DDR5 voltage with ECC error correction; no firmware updates are needed, and it is covered by a lifetime replacement warranty if a hardware fault occurs.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.