Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Green printed circuit board with black memory chips and gold edge connectors

NEMIX RAM

NEMIX RAM 16GB DDR5 4800 CL40 1Rx8 ECC RDIMM Supermicro H13SSW memory upgrade

SKU CH-1SG7-A6NHJ

16 GB DDR5 4800 CL40 ECC registered RDIMM validated for Supermicro H13SSW servers

  • Capacity16GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 16GB

Skatīt vēl 24 konfigurācijas
  • Registered ECC protects data integrity
  • DDR5-4800 speed matches server spec
  • 1Rx8 rank works fully populated
  • 1V voltage meets platform requirement
  • 288-pin RDIMM fits Supermicro H13SSW

Supermicro H13SSW DDR5 upgrade

This 16 GB DDR5 4800 registered ECC RDIMM is built to the exact rank, voltage and timing the Supermicro H13SSW motherboard expects. It installs as a single 288-pin module so the server recognises full capacity at rated speed.

Replacing slower or smaller DDR5 DIMMs

Swapping older DDR5 modules for this CL40 1.10 V part adds 16 GB per slot while keeping registered buffering and ECC active across every populated channel. The jump is worth it when your workload needs maximum registered-DIMM capacity without mixing ranks or voltages.

DDR5 registered DIMM limits

DDR5 RDIMMs require a motherboard that supports registered signalling and the correct population order; UDIMM or SODIMM slots will not accept the 288-pin form factor. Always verify the system manual for approved capacities and slot sequence before installation.

Priekšrocības

  • Registered ECC protects data integrity
  • DDR5-4800 speed matches server spec
  • 1Rx8 rank works fully populated
  • 1V voltage meets platform requirement
  • 288-pin RDIMM fits Supermicro H13SSW

Specifikācijas

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-618K1
Capacity16GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content16GB DDR5 4800MHz PC5-38400 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Citas šī modeļa versijas

Vēl 5 šajā sērijā

Viena saime, taču atšķirīga atmiņa, dzesētājs vai frekvence — salīdziniet, pirms izlemjat.

Jautājumi par šo preci

Does the 288-pin DDR5 RDIMM fit the Supermicro H13SSW motherboard slots?

Yes, the module is a 288-pin DDR5 RDIMM, which matches the form factor and registered architecture required by the H13SSW motherboard.

What is the correct installation step for the 1Rx8 registered ECC module on this board?

Power down the server, open the chassis, align the module's key notch with the DDR5 slot, press firmly until the ejector clips lock, then follow the motherboard manual's population order for registered DIMMs.

Will the 1.1V DDR5 module require any firmware update or replacement over time?

The module operates at the standard 1.1V DDR5 voltage with ECC error correction; no firmware updates are needed, and it is covered by a lifetime replacement warranty if a hardware fault occurs.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.