BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 $
0.00280578BTC
Laos
NEMIX RAM
NEMIX RAM DDR5 32GB (2x16GB) 5600MHz CL46 1.1V UDIMM Supermicro BH4SR2-25G memory upgrade
32 GB dual-channel DDR5 kit at 5600 MHz with CL46 latency and 1.1 V operation for Supermicro BH4SR2-25G boards
- Capacity32GB (2 x 16GB)
- SpeedDDR5 5600 (PC5 44800)
- ECCNo
- Buffered/RegisteredUnbuffered
- ChipsetMajor OEM Samsung, Micron, Hynix
- Voltage1.10V
- 32 GB total capacity from two 16 GB modules
- DDR5 5600 speed rated at PC5-44800
- Low 1.10 V operating voltage for efficiency
- CL46 CAS latency with 1Rx8 single-rank layout
- Validated for Supermicro BH4SR2-25G motherboard
32GB DDR5 kit for Supermicro BH4SR2-25G
This 32GB kit contains two 16GB DDR5 modules rated at 5600MHz with CL46 timings. It is built as non-ECC unbuffered UDIMM memory for desktop systems. The kit is validated for the Supermicro BH4SR2-25G motherboard. It suits users upgrading that specific platform.
Low voltage and no heat spreader
Each module runs at 1.1V, keeping power draw modest during typical desktop workloads. The absence of a heat spreader means the modules rely on case airflow alone. In normal use they operate silently with no active cooling. Power consumption stays low at standard JEDEC voltage.
Steady JEDEC operation under sustained load
At the rated 5600MHz and CL46 the modules maintain stock settings without overclocking headroom. Extended workloads stay within the 1.1V specification so thermals remain predictable. No thermal throttling is expected when case ventilation is adequate. Performance is consistent for long compute sessions.
Põhijooned
- 32 GB total capacity from two 16 GB modules
- DDR5 5600 speed rated at PC5-44800
- Low 1.10 V operating voltage for efficiency
- CL46 CAS latency with 1Rx8 single-rank layout
- Validated for Supermicro BH4SR2-25G motherboard
Tehnilised andmed
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Memory |
| Model | DDR5 Non-ECC Unbuffered UDIMM Memory |
| Part Number | MD44800-618K2 |
| Capacity | 32GB (2 x 16GB) |
| Speed | DDR5 5600 (PC5 44800) |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Voltage | 1.10V |
| Compatible System | Supermicro |
| CAS Latency | CL46 |
| Heat Spreader | No |
| Type | 288-Pin DDR5 UDIMM |
| Rank | 1Rx8 |
| Features | DDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible |
| Package Content | 32GB (2 x 16GB) DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN Non-ECC UDIMM KIT |
Küsimused selle toote kohta
How do I install the 288-Pin DDR5 UDIMM modules in my Supermicro BH4SR2-25G motherboard?
Align the notch on each 1Rx8 module with the slot key, press down firmly until the retention clips click, and populate the channels specified in the motherboard manual for dual-channel operation.
Will the Samsung, Micron or Hynix chips on these modules need replacement during the system's life?
The memory chips are solid-state with no moving parts and are rated for continuous operation at 1.1V; they do not have a scheduled replacement interval.
At what point does the CL46 latency limit throughput during sustained workloads?
CL46 sets the minimum command-to-data delay at 5600 MT/s; under sustained loads the memory controller cannot issue new reads faster than this timing allows.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
