OEM Industries
OEM Industries SMA06E05UF CPU cooler 60mm 5V .30A 3-pin pitch 55mm
A 60 mm ball-bearing fan drawing 5 V at .30 A with a 3-pin connector and 55 mm mounting pitch for notebook CPU cooling
- ColorBlack
- TypeFan only
- Fan Size60mm
- Bearing TypeBall
- Power Connector3 Pin
- LEDNo
- Compact 60 mm frame fits tight laptop bays
- Ball bearing ensures durable, quiet operation
- Low 5 V, 0.30 A draw saves battery life
- Standard 3-pin connector enables simple motherboard hookup
- 55 mm pitch-row spacing matches common notebook mounts
Compact 60 mm notebook cooler
The OEM Industries SMA06E05UF is a 60 mm square fan measuring 10 mm thick. It runs on 5 V DC at 0.30 A and connects through a three-pin header with a 55 mm pitch. The ball-bearing rotor and black frame are built for slim notebook chassis.
Suits tight laptop refreshes
Technicians repairing or upgrading a notebook that uses a 5 V three-pin fan with this exact mounting pitch will find a direct fit. Systems that require a larger frame, a different voltage or a four-wire PWM connector cannot use this cooler.
5 V three-pin power requirement
The cooler draws 0.30 A from a 5 V rail through its three-pin connector. If the target board supplies only a higher voltage or a different header layout the fan will not operate.
Põhijooned
- Compact 60 mm frame fits tight laptop bays
- Ball bearing ensures durable, quiet operation
- Low 5 V, 0.30 A draw saves battery life
- Standard 3-pin connector enables simple motherboard hookup
- 55 mm pitch-row spacing matches common notebook mounts
Tehnilised andmed
| Model | SMA06E05UF |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 60mm |
| Bearing Type | Ball |
| Power Connector | 3 Pin |
| LED | No |
Küsimused selle toote kohta
Will the 55 mm pitch-row holes match my laptop's existing mounting points?
The cooler uses a 55 mm pitch-row spacing between its two mounting holes; measure your board's hole centres to confirm they match this exact distance.
How do I connect the 3-pin lead to a 5 V header without reversing polarity?
Align the keyed 3-pin connector with the motherboard's 5 V fan header — the plastic tab prevents backward insertion — then press firmly until seated.
When should I replace the ball-bearing fan in this 60 mm cooler?
Replace the fan when bearing noise becomes audible or RPM drops noticeably below the rated .30 A current draw at 5 V.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear



