Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Green printed circuit board with black memory chips and gold edge contacts

OWC

OWC 16GB DDR4 2666MHz CL19 1.2V 288-Pin UDIMM HP ProDesk 400 G6 600 G5 memory upgrade

SKU CH-TGWK-SGSCS

A 16 GB DDR4 2666 MHz CL19 UDIMM for HP ProDesk 400 G6 and 600 G5 desktops

  • Capacity16GB
  • Type288-Pin DDR4 Non-ECC UDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.2V
  • ECCNo
  • Boosts multitasking with 16GB DDR4 capacity
  • Speeds up workloads at 2666MHz CL19 timing
  • Low 1.2V draw cuts power consumption
  • Fits HP ProDesk 400 G6 and 600 G5 models
  • JEDEC compliant for reliable drop-in upgrades

16GB DDR4 upgrade for HP ProDesk

This 16GB DDR4 module runs at 2666MHz with CL19 latency and 1.2V operation. It fits HP ProDesk 400 G6 and 600 G5 SFF and Tower systems using 288-pin UDIMM slots. The unbuffered non-ECC design matches OEM specifications for these desktops.

Replaces slower or smaller DDR4 DIMMs

It steps up from 2133MHz or 2400MHz modules thanks to backward compatibility at those speeds. The jump is worth it when your ProDesk currently has less than 16GB per slot or runs at lower JEDEC frequencies. Each stick is tested to meet JEDEC standards for a warranty-safe upgrade.

Suits owners of listed HP ProDesk models

Builders needing ECC registered memory or a different form factor should look elsewhere. Systems outside the 400 G6 and 600 G5 families are not covered by the validated compatibility list. Buyers wanting higher frequencies than 2666MHz will need a different module.

Põhijooned

  • Boosts multitasking with 16GB DDR4 capacity
  • Speeds up workloads at 2666MHz CL19 timing
  • Low 1.2V draw cuts power consumption
  • Fits HP ProDesk 400 G6 and 600 G5 models
  • JEDEC compliant for reliable drop-in upgrades

Tehnilised andmed

BrandOWC
Part Number2U6D42R816GB
Capacity16GB
Type288-Pin DDR4 Non-ECC UDIMM
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
Heat SpreaderNo
Compatible SystemHP ProDesk 400 G6 SFF
HP ProDesk 400 G6 Tower
HP ProDesk 600 G5 SFF
HP ProDesk 600 G5 Tower

Selle mudeli teised versioonid

5 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

Does the 288-pin DDR4 UDIMM fit the HP ProDesk 400 G6 SFF and Tower plus 600 G5 SFF and Tower?

Yes, the module is validated for HP ProDesk 400 G6 SFF, 400 G6 Tower, 600 G5 SFF and 600 G5 Tower.

What is the common mistake when installing this 16GB DDR4 2666MHz CL19 stick?

Not pressing the module straight down until both retention clips snap shut, leaving it partially seated and causing boot failure.

Will this 1.2V non-ECC memory need replacement or maintenance later?

No scheduled maintenance is required; the module is rated for the system lifetime and carries a limited lifetime warranty.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.