Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green printed circuit board with black memory chips and gold edge contacts

OWC

OWC 16GB DDR4 2666MHz CL19 1.2V 288-Pin UDIMM HP ProDesk 400 G6 600 G5 memory upgrade

SKU CH-TGWK-SGSCS

A 16 GB DDR4 2666 MHz CL19 UDIMM for HP ProDesk 400 G6 and 600 G5 desktops

  • Capacity16GB
  • Type288-Pin DDR4 Non-ECC UDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.2V
  • ECCNo
  • Boosts multitasking with 16GB DDR4 capacity
  • Speeds up workloads at 2666MHz CL19 timing
  • Low 1.2V draw cuts power consumption
  • Fits HP ProDesk 400 G6 and 600 G5 models
  • JEDEC compliant for reliable drop-in upgrades

16GB DDR4 upgrade for HP ProDesk

This 16GB DDR4 module runs at 2666MHz with CL19 latency and 1.2V operation. It fits HP ProDesk 400 G6 and 600 G5 SFF and Tower systems using 288-pin UDIMM slots. The unbuffered non-ECC design matches OEM specifications for these desktops.

Replaces slower or smaller DDR4 DIMMs

It steps up from 2133MHz or 2400MHz modules thanks to backward compatibility at those speeds. The jump is worth it when your ProDesk currently has less than 16GB per slot or runs at lower JEDEC frequencies. Each stick is tested to meet JEDEC standards for a warranty-safe upgrade.

Suits owners of listed HP ProDesk models

Builders needing ECC registered memory or a different form factor should look elsewhere. Systems outside the 400 G6 and 600 G5 families are not covered by the validated compatibility list. Buyers wanting higher frequencies than 2666MHz will need a different module.

Helstu kostir

  • Boosts multitasking with 16GB DDR4 capacity
  • Speeds up workloads at 2666MHz CL19 timing
  • Low 1.2V draw cuts power consumption
  • Fits HP ProDesk 400 G6 and 600 G5 models
  • JEDEC compliant for reliable drop-in upgrades

Tæknilýsing

BrandOWC
Part Number2U6D42R816GB
Capacity16GB
Type288-Pin DDR4 Non-ECC UDIMM
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
Heat SpreaderNo
Compatible SystemHP ProDesk 400 G6 SFF
HP ProDesk 400 G6 Tower
HP ProDesk 600 G5 SFF
HP ProDesk 600 G5 Tower

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

Does the 288-pin DDR4 UDIMM fit the HP ProDesk 400 G6 SFF and Tower plus 600 G5 SFF and Tower?

Yes, the module is validated for HP ProDesk 400 G6 SFF, 400 G6 Tower, 600 G5 SFF and 600 G5 Tower.

What is the common mistake when installing this 16GB DDR4 2666MHz CL19 stick?

Not pressing the module straight down until both retention clips snap shut, leaving it partially seated and causing boot failure.

Will this 1.2V non-ECC memory need replacement or maintenance later?

No scheduled maintenance is required; the module is rated for the system lifetime and carries a limited lifetime warranty.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.