Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Green rectangular circuit board with gold edge connectors and black memory chips on both sides

OWC

OWC 4GB DDR3 1600 CL11 204-pin 1.5V laptop RAM

SKU CH-7AT5-Q0QXH

A 4 GB DDR3 1600 MHz SODIMM module with CL11 latency and 1.5 V operation for laptop, mini PC or NAS upgrades

  • Capacity4GB
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Voltage1.5V
  • ECCNo

Capacity 4GB

  • Boosts responsiveness with a 4 GB DDR3 1600 MHz module
  • Meets JEDEC and RoHS standards for a warranty-safe upgrade
  • Simple DIY install fits most laptops and all-in-one systems
  • Runs at standard 1.5 V without ECC or buffering
  • Compatible with laptops, mini PCs and NAS devices

4GB DDR3 SODIMM for laptops and NAS

This module adds four gigabytes of DDR3 1600 memory to laptops, all-in-one PCs and compatible NAS units. It targets users who need a straightforward capacity increase without changing voltage or form factor. The 204-pin SO-DIMM fits standard DDR3 slots in those device classes.

JEDEC-compliant 1.5V unbuffered design

The stick follows JEDEC PC3-12800 timings at CL11 and runs at the standard 1.5 volts. Because it is non-ECC and unbuffered, it works in consumer platforms that do not support registered or error-correcting modules. RoHS compliance means the components meet restricted-substance rules.

Simple slot insertion with matching specs

Installation consists of aligning the notch on the 204-pin edge connector and pressing until the side clips engage. Most issues arise when the host system requires a different voltage, a higher density per rank, or an ECC module, so verifying the device manual before purchase avoids returns.

Põhijooned

  • Boosts responsiveness with a 4 GB DDR3 1600 MHz module
  • Meets JEDEC and RoHS standards for a warranty-safe upgrade
  • Simple DIY install fits most laptops and all-in-one systems
  • Runs at standard 1.5 V without ECC or buffering
  • Compatible with laptops, mini PCs and NAS devices

Tehnilised andmed

BrandOWC
Part Number1S6D32R804GB
Capacity4GB
Type204-Pin DDR3 SO-DIMM
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Heat SpreaderNo
Recommend UseLaptops, All-in-One Systems, and NAS Systems

Selle mudeli teised versioonid

3 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

Will the module need a heat spreader added later for sustained loads?

No heat spreader is included or required; the DDR3 1600 CL11 1.5V SODIMM runs within JEDEC thermal limits without one.

What limit appears first when the memory runs continuously at 1600 MHz?

The CL11 latency at 1.5V is the governing timing constraint under sustained DDR3 1600 operation.

How much heat and power does the 4 GB stick produce during all-day use?

At 1.5V the module draws minimal power and generates low heat typical for a non-ECC DDR3 1600 SODIMM.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.