Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Grey ATX power supply unit with reduced depth and 80mm fan

Replace Power

Replace Power 420W ATX Power Supply Reduced Depth

SKU CH-WRQ3-H9887

Reduced-depth ATX unit delivers 420 W peak and 280 W continuous with 20+4-pin, 4-pin CPU, three SATA and two Molex connectors

  • ColorGrey
  • TypeATX
  • Fans1
  • Weight4
  • Fits compact cases with reduced 5.86" depth
  • Powers HP desktops including 710 712 714 720 735 1010 models
  • Delivers 420W peak and 280W continuous output
  • Runs on 110V or 220V mains at 47 to 63Hz
  • Connects SATA drives motherboard and CPU with built-in cables

Reduced Depth ATX Power Supply

This Replace Power unit delivers up to 420 W peak and 280 W continuous power in a shortened ATX form factor. It is built as a direct replacement for HP A710m, A710n, A712n, A714x, A720n, A735w and A1010y CTO desktops. The compact depth helps it fit chassis where a standard-length PSU would foul internal components. A single 80 mm fan provides cooling for stable long-term operation.

Compatibility Check Before Ordering

Verify that your motherboard uses a 24-pin (20+4) ATX connector and a 4-pin CPU power header. Count the drives you plan to power: the harness includes three SATA 15-pin plugs, two Molex 4-pin plugs and one floppy 4-pin plug. Confirm the case can accept a grey unit measuring 5.86" x 3.3" x 4" and that the AC inlet matches your local 110 V or 220 V supply at 47–63 Hz. This supply is not for builders who need more connectors than listed or a higher continuous wattage rating.

Thermals Noise and Power Draw

The 80 mm fan runs at speeds that keep internal temperatures low while maintaining low ripple and noise output. At typical loads the unit draws up to 280 W total from the mains and holds output for at least 17 ms during brief input interruptions. Rise time stays under 70 ms, and the +12 V rails share the load with +5 V, +3.3 V, -12 V and +5 V standby rails. Hi-Pot testing, ROHS and CE marks confirm baseline safety compliance.

Põhijooned

  • Fits compact cases with reduced 5.86" depth
  • Powers HP desktops including 710 712 714 720 735 1010 models
  • Delivers 420W peak and 280W continuous output
  • Runs on 110V or 220V mains at 47 to 63Hz
  • Connects SATA drives motherboard and CPU with built-in cables

Tehnilised andmed

BrandReplace Power
ModelHP A710m A710n A712n A714x A720n A735w A1010y CTO
ColorGrey
TypeATX
Fans1
Weight4

Küsimused selle toote kohta

What connectors come attached to the Replace Power 420W unit?

The supply ships with a fixed 24 (20+4) pin motherboard connector, a 4-pin CPU plug, three SATA 15-pin leads, two Molex 4-pin leads and one floppy 4-pin lead.

Should I pick the 420 W peak or the 280 W continuous rating for my HP desktop?

Use the 280 W total continuous figure for everyday loads; the 420 W peak is only for brief transients.

Will the 5.86 inch depth fit my HP A710m chassis?

Yes — the reduced 5.86" depth is designed to slide into standard ATX bays in HP A710m, A710n, A712n, A714x, A720n, A735w and A1010y models without protruding.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.