Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Grey ATX power supply unit with reduced depth and 80mm fan

Replace Power

Replace Power 420W ATX Power Supply Reduced Depth

SKU CH-WRQ3-H9887

Reduced-depth ATX unit delivers 420 W peak and 280 W continuous with 20+4-pin, 4-pin CPU, three SATA and two Molex connectors

  • ColorGrey
  • TypeATX
  • Fans1
  • Weight4
  • Fits compact cases with reduced 5.86" depth
  • Powers HP desktops including 710 712 714 720 735 1010 models
  • Delivers 420W peak and 280W continuous output
  • Runs on 110V or 220V mains at 47 to 63Hz
  • Connects SATA drives motherboard and CPU with built-in cables

Reduced Depth ATX Power Supply

This Replace Power unit delivers up to 420 W peak and 280 W continuous power in a shortened ATX form factor. It is built as a direct replacement for HP A710m, A710n, A712n, A714x, A720n, A735w and A1010y CTO desktops. The compact depth helps it fit chassis where a standard-length PSU would foul internal components. A single 80 mm fan provides cooling for stable long-term operation.

Compatibility Check Before Ordering

Verify that your motherboard uses a 24-pin (20+4) ATX connector and a 4-pin CPU power header. Count the drives you plan to power: the harness includes three SATA 15-pin plugs, two Molex 4-pin plugs and one floppy 4-pin plug. Confirm the case can accept a grey unit measuring 5.86" x 3.3" x 4" and that the AC inlet matches your local 110 V or 220 V supply at 47–63 Hz. This supply is not for builders who need more connectors than listed or a higher continuous wattage rating.

Thermals Noise and Power Draw

The 80 mm fan runs at speeds that keep internal temperatures low while maintaining low ripple and noise output. At typical loads the unit draws up to 280 W total from the mains and holds output for at least 17 ms during brief input interruptions. Rise time stays under 70 ms, and the +12 V rails share the load with +5 V, +3.3 V, -12 V and +5 V standby rails. Hi-Pot testing, ROHS and CE marks confirm baseline safety compliance.

Přednosti

  • Fits compact cases with reduced 5.86" depth
  • Powers HP desktops including 710 712 714 720 735 1010 models
  • Delivers 420W peak and 280W continuous output
  • Runs on 110V or 220V mains at 47 to 63Hz
  • Connects SATA drives motherboard and CPU with built-in cables

Specifikace

BrandReplace Power
ModelHP A710m A710n A712n A714x A720n A735w A1010y CTO
ColorGrey
TypeATX
Fans1
Weight4

Otázky k tomuto produktu

What connectors come attached to the Replace Power 420W unit?

The supply ships with a fixed 24 (20+4) pin motherboard connector, a 4-pin CPU plug, three SATA 15-pin leads, two Molex 4-pin leads and one floppy 4-pin lead.

Should I pick the 420 W peak or the 280 W continuous rating for my HP desktop?

Use the 280 W total continuous figure for everyday loads; the 420 W peak is only for brief transients.

Will the 5.86 inch depth fit my HP A710m chassis?

Yes — the reduced 5.86" depth is designed to slide into standard ATX bays in HP A710m, A710n, A712n, A714x, A720n, A735w and A1010y models without protruding.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.