Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Two green DDR2 DIMM sticks with gold contacts

Simmtec, Inc

Simmtec, Inc 4GB (2x2GB) DDR2 DIMM 240-pin 667MHz PC2-5400/PC2-5300 for DFI LANPARTY LP UT 790FX-M2R

SKU CH-CP3D-2SYNM

4GB DDR2 kit with two 240-pin DIMMs at 667MHz PC2-5400/PC2-5300 for DFI LANPARTY LP UT 790FX-M2R

  • Capacity4GB (2 x 2GB)
  • 4 GB total capacity from two 2 GB modules
  • 240-pin DDR2 DIMM fits the motherboard slots
  • 667 MHz PC2-5400/PC2-5300 speed rating
  • Tested 100 % compatible with DFI LANPARTY LP UT 790FX-M2R

DDR2 DIMM kit for DFI LANPARTY

This kit supplies 4GB of DDR2 memory in a matched pair of 2GB modules. The 240-pin DIMMs run at 667MHz and are rated for PC2-5400 and PC2-5300 operation. They are validated for 100% compatibility with the DFI LANPARTY LP UT 790FX-M2R motherboard.

Upgrade path for older DDR2 systems

The modules replace slower or mismatched DDR2 sticks in compatible boards, restoring dual-channel bandwidth at the rated 667MHz speed. The jump is worth it when the existing memory is limiting multitasking or causing instability on this specific platform.

Põhijooned

  • 4 GB total capacity from two 2 GB modules
  • 240-pin DDR2 DIMM fits the motherboard slots
  • 667 MHz PC2-5400/PC2-5300 speed rating
  • Tested 100 % compatible with DFI LANPARTY LP UT 790FX-M2R

Tehnilised andmed

Capacity4GB (2 x 2GB)

Küsimused selle toote kohta

Will the 240-pin DDR2 DIMMs fit the DFI LANPARTY LP UT 790FX-M2R board?

Yes — the kit is specified as 100% compatible with the DFI LANPARTY LP UT 790FX-M2R and uses the standard 240-pin DDR2 DIMM form factor that board requires.

What is the correct way to seat the two 2GB modules, and what step do people often miss?

Align the notch on each 240-pin DDR2 module with the slot key, press straight down until the retention clips click, and ensure both sticks are fully latched — the most common mistake is stopping when the module feels tight but before the clips engage.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.