Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Green circuit board with black memory chips and gold edge connectors

Simmtec, Inc

Simmtec, Inc 4GB DDR2 DIMM 240Pin 800Mhz PC2-6400 PC2-6300 CL5

SKU CH-YD1A-F11QK

A 4 GB DDR2 desktop memory module running at 800 MHz with CL5 latency and 1.8 V operation

  • Capacity4GB
  • CAS LatencyCL5
  • 4 GB DDR2 capacity for desktop upgrades
  • 800 MHz PC2-6400/PC2-6300 speed rating
  • CL5 CAS latency for responsive timing
  • 8 V non-ECC 240-pin DIMM module

4GB DDR2 800MHz Desktop Module

This Simmtec module provides 4GB of DDR2 desktop memory running at 800MHz with PC2-6400 and PC2-6300 ratings. It uses a standard 240-pin DIMM form factor and operates at 1.8V with CL5 CAS latency. The stick is non-ECC and non-parity, designed as a straightforward capacity upgrade for compatible legacy systems.

Suits older DDR2 platforms needing maximum

Builders maintaining desktop boards that accept 4GB unbuffered DDR2 DIMMs at 1.8V will find this module matches the required voltage, pin count and latency. It is not suitable for servers requiring registered or ECC memory, nor for any system limited to lower-density modules or different voltage and pin configurations.

Põhijooned

  • 4 GB DDR2 capacity for desktop upgrades
  • 800 MHz PC2-6400/PC2-6300 speed rating
  • CL5 CAS latency for responsive timing
  • 8 V non-ECC 240-pin DIMM module

Tehnilised andmed

Capacity4GB
CAS LatencyCL5

Küsimused selle toote kohta

Does this 240-pin DDR2 DIMM need a 1.8V memory slot?

Yes, the module runs at 1.8V and must be installed in a DDR2 slot that supplies that voltage.

What is the correct way to seat the module so the retention clips engage?

Align the notch with the slot key, press down firmly until both side clips click into the notches on the PCB.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.