Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
Green circuit board with black memory chips and gold edge connectors

Simmtec, Inc

Simmtec, Inc 4GB DDR2 DIMM 240Pin 800Mhz PC2-6400 PC2-6300 CL5

SKU CH-YD1A-F11QK

A 4 GB DDR2 desktop memory module running at 800 MHz with CL5 latency and 1.8 V operation

  • Capacity4GB
  • CAS LatencyCL5
  • 4 GB DDR2 capacity for desktop upgrades
  • 800 MHz PC2-6400/PC2-6300 speed rating
  • CL5 CAS latency for responsive timing
  • 8 V non-ECC 240-pin DIMM module

4GB DDR2 800MHz Desktop Module

This Simmtec module provides 4GB of DDR2 desktop memory running at 800MHz with PC2-6400 and PC2-6300 ratings. It uses a standard 240-pin DIMM form factor and operates at 1.8V with CL5 CAS latency. The stick is non-ECC and non-parity, designed as a straightforward capacity upgrade for compatible legacy systems.

Suits older DDR2 platforms needing maximum

Builders maintaining desktop boards that accept 4GB unbuffered DDR2 DIMMs at 1.8V will find this module matches the required voltage, pin count and latency. It is not suitable for servers requiring registered or ECC memory, nor for any system limited to lower-density modules or different voltage and pin configurations.

Poudarki

  • 4 GB DDR2 capacity for desktop upgrades
  • 800 MHz PC2-6400/PC2-6300 speed rating
  • CL5 CAS latency for responsive timing
  • 8 V non-ECC 240-pin DIMM module

Specifikacije

Capacity4GB
CAS LatencyCL5

Vprašanja o tem izdelku

Does this 240-pin DDR2 DIMM need a 1.8V memory slot?

Yes, the module runs at 1.8V and must be installed in a DDR2 slot that supplies that voltage.

What is the correct way to seat the module so the retention clips engage?

Align the notch with the slot key, press down firmly until both side clips click into the notches on the PCB.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.