Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Small black graphics card fan with 55mm blades and 42mm mounting holes, 3-pin connector

SXDOOL

SXDOOL MGT6012YR-O15 graphics card fan 42mm hole distance 55mm blade 0.37A 3-pin

SKU CH-A34Z-BVF3P

Replaces a graphics card cooler with a 55 mm blade, 42 mm mounting spacing and a three-pin 0.37 A connector

  • Direct replacement for compatible graphics cards with 42mm hole spacing
  • Three-wire connection enables speed monitoring through standard 3-pin header
  • 55mm blade diameter moves air across heatsink surfaces efficiently
  • Low 0.37A current draw reduces load on graphics card power circuitry
  • Compact 601 form factor fits tight spaces between expansion slots

SXDOOL MGT6012YR-O15 42 mm Fan

The SXDOOL MGT6012YR-O15 is a replacement graphics card fan with a 42 mm mounting hole spacing and a 55 mm blade diameter. It connects via a 3-pin plug and draws 0.37 A. The unit ships new in a 15 cm cube package weighing 0.5 kg.

Suits DIY GPU cooler repairs; not for case airflow

This fan is built for graphics card cooler assemblies that use the exact 42 mm hole pattern. It will not fit standard case fan mounts or coolers with different screw spacing. Buyers needing chassis intake or exhaust should look at case-specific fans instead.

55 mm blade moves air for targeted GPU cooling

The compact blade provides focused airflow directly over a graphics card heatsink. It handles the thermal load of the original cooler it replaces. It runs out of capacity when the heatsink design demands higher static pressure or a larger blade area than 55 mm can supply.

Põhijooned

  • Direct replacement for compatible graphics cards with 42mm hole spacing
  • Three-wire connection enables speed monitoring through standard 3-pin header
  • 55mm blade diameter moves air across heatsink surfaces efficiently
  • Low 0.37A current draw reduces load on graphics card power circuitry
  • Compact 601 form factor fits tight spaces between expansion slots

Tehnilised andmed

Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.

Küsimused selle toote kohta

Does my graphics card have a 42mm mounting pattern for this 55mm blade fan?

The fan uses a 42mm square hole spacing and a 55mm blade diameter, so it fits coolers drilled to that exact pattern.

Will the 3-pin connector work with an older 4-pin GPU fan header?

A 3-pin plug fits a 4-pin header; the fan will run at full speed unless the header supports voltage control.

How can I confirm the fan is drawing 0.37A after installation?

Check the GPU fan RPM in monitoring software and verify the current draw matches the 0.37A rating under load.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.