Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Rectangular grey metal 1U server PSU with dual 40mm fans and sliding power connectors

TOPOWER

TOPOWER 300W 1U-PFC -5V server power supply T30U-HY1

SKU CH-M4ZE-DFVWZ

A 300W 1U server power supply with PFC, -5V rail, sliding 20/24-pin and 4/8-pin connectors, dual 40mm fans and OVP/OCP/SCP protection

  • Maximum Power300W
  • 300W output powers demanding server workloads
  • 1U form factor fits standard rack enclosures
  • Forward circuitry design improves energy efficiency
  • Dual 40mm fans with thermal control reduce noise
  • OVP, OCP and SCP safeguards protect connected hardware

Direct replacement for TURBO-COOL 300

This 300W 1U server power supply replaces the TURBO-COOL 300 1U-PFC T30U-HY1 unit. It fits the same 100 x 40 x 200mm footprint and uses matching 20/24 pin and 4/8 pin main sliding connectors. The swap is worth it when the original unit fails or when a spare is needed for identical chassis.

Forward circuitry with -5V rail

The forward circuitry design delivers 300W maximum power and includes a -5V rail for legacy server boards. OVP, OCP and SCP protection cover all outputs. The grey iron case houses two 40mm fans driven by thermally controlled Silent Control Technology. Low ripple and noise keep power stable for industrial PCs.

Thermally controlled dual-fan cooling

Two 40mm fans spin only as fast as internal temperature demands, so acoustic output stays low during typical loads. Under sustained load the fans ramp up to maintain safe component temperatures without sudden speed jumps. The sliding main connectors ease installation in tight 1U bays.

Põhijooned

  • 300W output powers demanding server workloads
  • 1U form factor fits standard rack enclosures
  • Forward circuitry design improves energy efficiency
  • Dual 40mm fans with thermal control reduce noise
  • OVP, OCP and SCP safeguards protect connected hardware

Tehnilised andmed

Series1U
Maximum Power300W

Küsimused selle toote kohta

What case clearance does the 100 x 40 x 200 mm 1U form factor need?

The unit fits a standard 1U rack slot 100 mm wide, 40 mm high and 200 mm deep; ensure the chassis rail depth allows the full 200 mm length and that the rear I/O cut-out matches the sliding connector panel.

How do the 20/24 pin and 4/8 pin main sliding connectors install, and what step is often missed?

Slide each connector block onto the motherboard header until the latch clicks; the step often missed is confirming both the 24-pin and the 8-pin CPU power latches are fully seated before powering on.

What maintenance do the twin 40 mm fans with thermally controlled cooling need?

Clean the fan grilles with compressed air when dust builds up; if a fan develops bearing noise or stops spinning under load, replace the 40 mm unit to restore the thermally controlled cooling curve.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.