Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
Rectangular grey metal 1U server PSU with dual 40mm fans and sliding power connectors

TOPOWER

TOPOWER 300W 1U-PFC -5V server power supply T30U-HY1

SKU CH-M4ZE-DFVWZ

A 300W 1U server power supply with PFC, -5V rail, sliding 20/24-pin and 4/8-pin connectors, dual 40mm fans and OVP/OCP/SCP protection

  • Maximum Power300W
  • 300W output powers demanding server workloads
  • 1U form factor fits standard rack enclosures
  • Forward circuitry design improves energy efficiency
  • Dual 40mm fans with thermal control reduce noise
  • OVP, OCP and SCP safeguards protect connected hardware

Direct replacement for TURBO-COOL 300

This 300W 1U server power supply replaces the TURBO-COOL 300 1U-PFC T30U-HY1 unit. It fits the same 100 x 40 x 200mm footprint and uses matching 20/24 pin and 4/8 pin main sliding connectors. The swap is worth it when the original unit fails or when a spare is needed for identical chassis.

Forward circuitry with -5V rail

The forward circuitry design delivers 300W maximum power and includes a -5V rail for legacy server boards. OVP, OCP and SCP protection cover all outputs. The grey iron case houses two 40mm fans driven by thermally controlled Silent Control Technology. Low ripple and noise keep power stable for industrial PCs.

Thermally controlled dual-fan cooling

Two 40mm fans spin only as fast as internal temperature demands, so acoustic output stays low during typical loads. Under sustained load the fans ramp up to maintain safe component temperatures without sudden speed jumps. The sliding main connectors ease installation in tight 1U bays.

Poudarki

  • 300W output powers demanding server workloads
  • 1U form factor fits standard rack enclosures
  • Forward circuitry design improves energy efficiency
  • Dual 40mm fans with thermal control reduce noise
  • OVP, OCP and SCP safeguards protect connected hardware

Specifikacije

Series1U
Maximum Power300W

Vprašanja o tem izdelku

What case clearance does the 100 x 40 x 200 mm 1U form factor need?

The unit fits a standard 1U rack slot 100 mm wide, 40 mm high and 200 mm deep; ensure the chassis rail depth allows the full 200 mm length and that the rear I/O cut-out matches the sliding connector panel.

How do the 20/24 pin and 4/8 pin main sliding connectors install, and what step is often missed?

Slide each connector block onto the motherboard header until the latch clicks; the step often missed is confirming both the 24-pin and the 8-pin CPU power latches are fully seated before powering on.

What maintenance do the twin 40 mm fans with thermally controlled cooling need?

Clean the fan grilles with compressed air when dust builds up; if a fan develops bearing noise or stops spinning under load, replace the 40 mm unit to restore the thermally controlled cooling curve.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.