A-Tech 2GB DDR2 667MHz PC2-5300 UDIMM CL5 1.8V 240-Pin Desktop RAM
- 2GB
- DDR2 667 (PC2 5300)
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
A-Tech
A 2 GB dual-channel kit of DDR2 800 MHz desktop memory running at 1.8 V with CL6 timing on 240-pin DIMMs
Capacity 2GB (2 x 1GB)
Speed DDR2 800 (PC2 6400)
This A-Tech kit delivers 2GB of DDR2 memory as two matched 1GB modules running at 800MHz with PC2-6400 bandwidth. The unbuffered, non-ECC DIMMs operate at the standard 1.8V DDR2 voltage and use the 240-pin desktop form factor. It is designed as a straightforward capacity upgrade for compatible desktop systems.
The dual-channel configuration benefits owners of older AMD and Intel desktop platforms that support DDR2 800MHz memory and have two available DIMM slots. Systems requiring ECC, registered modules, or a different DDR generation will not accept this kit, so verifying the motherboard specification is essential before purchase.
The modules use the 240-pin DDR2 DIMM interface, which is the single physical and electrical specification that determines whether they fit and function in a given motherboard. Only boards designed for DDR2 memory with this pin layout can use the kit.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR2 Desktop Memory RAM |
| Capacity | 2GB (2 x 1GB) |
| Speed | DDR2 800 (PC2 6400) |
| Tested Frequency | 800 |
| Voltage | 1.80V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Multi-channel Kit | Dual Channel Kit |
| Recommend Use | AMD & Intel Compatible |
Druge verzije ovog modela
Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.
These modules use the standard 240-pin DDR2 DIMM form factor, so they install in any desktop board with DDR2 240-pin slots.
Align the notch on each module with the slot key, press down firmly until both side clips snap shut; the step often missed is not pressing hard enough to engage both clips.
No firmware is involved; the memory runs at the standard 1.8V and only needs replacement if a module fails or you want more capacity.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?