NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
A-Tech
8GB DDR3L 1333MHz ECC registered DIMM, 2Rx4 at 1.35V for server upgrades
This 8GB DDR3L module is built for servers and workstations that require registered ECC memory. It replaces Hynix HMT41GV7BMR4A-H9 and HMT41GV7CMR4A-H9 parts in compatible systems. The module is not suited for desktop boards that only accept unbuffered non-ECC DIMMs.
The stick uses a 240-pin DIMM form factor with a 2Rx4 organisation and major-brand chips. Registered signalling and on-board ECC reduce electrical load on the memory controller and correct single-bit errors, which is essential for 24/7 server workloads. Buyers needing unbuffered or non-ECC memory should look elsewhere.
Rated at 1.35V, the DDR3L module draws less power and generates less heat than standard 1.5V DDR3 at the same 1333MHz CL9 speed. Lower thermals help keep chassis fans quiet in dense rack environments. Systems that cannot run DDR3L at 1.35V will not support this module.
| Brand | A-Tech |
|---|---|
| Series | Compatible Replacement for Hynix |
| Model | HMT41GV7BMR4A-H9, HMT41GV7CMR4A-H9 |
| Capacity | 8GB |
| Speed | DDR3L 1333 (PC3L 10600) |
| CAS Latency | CL9 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | HMT41GV7BMR4A-H9, HMT41GV7CMR4A-H9 |
Yes, the module runs at DDR3L 1333 (PC3L-10600) with CL9 latency, so throughput is limited to that rated speed.
It fits a standard DDR3 240-pin DIMM socket; the low-voltage DDR3L keying matches DDR3 slots that support 1.35V operation.
Ensure the server supports registered ECC memory and enable ECC in the BIOS after seating the module firmly until the retention clips lock.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?