Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Green 288-pin DDR4 RDIMM module with black memory chips and silver contacts

A-Tech

A-Tech 8GB DDR4 2400MHz ECC Registered RDIMM 1Rx8 CL17 1.2V Server Memory

SKU CH-KPT7-MRY4F

An 8 GB registered DDR4 module with ECC, 2400 MHz speed and CL17 latency for server workloads

  • Capacity8GB
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.20V
  • ECCYes
  • Buffered/RegisteredRegistered
  • ECC registered design protects data integrity in critical workloads
  • Supermicro certification confirms validated compatibility with supported platforms
  • Micron DDR4 2400 MHz chips deliver 19200 MB/s bandwidth at CL17 latency
  • Single-rank 1Rx8 organisation simplifies memory-channel population
  • Standard 1.2 V operation reduces power draw per module

Supermicro-certified DDR4 RDIMM

This 8 GB registered module carries Supermicro certification and uses Micron chips to deliver ECC-protected DDR4 2400 memory for server platforms. The single-rank 1Rx8 organisation keeps electrical loading low on memory channels. It installs in standard 288-pin RDIMM slots and runs at the JEDEC-standard 1.2 V.

Steady throughput on registered channels

Registered buffering and ECC correction maintain data integrity during continuous workloads such as virtualisation hosts or database servers. The CL17 latency at 2400 MT/s provides predictable bandwidth without the variability seen on unbuffered consumer modules. Error detection and correction operate transparently under sustained load.

Straightforward slot installation

Align the key notch with the 288-pin socket and press until the retention clips engage; no tools or firmware steps are required. Systems that accept only unbuffered UDIMMs or that limit rank count per channel will not recognise this module. Verify the platform’s qualified-vendor list before ordering to avoid a mismatch.

Istaknuto

  • ECC registered design protects data integrity in critical workloads
  • Supermicro certification confirms validated compatibility with supported platforms
  • Micron DDR4 2400 MHz chips deliver 19200 MB/s bandwidth at CL17 latency
  • Single-rank 1Rx8 organisation simplifies memory-channel population
  • Standard 1.2 V operation reduces power draw per module

Specifikacije

BrandSuperMicro
SeriesSupermicro Certified
ModelMEM-DR480L-CL03-ER24
Capacity8GB
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMicron Chipset
FeaturesSupermicro Certified MEM-DR480L-CL03-ER24 (MTA9ASF1G72PZ-2G3B1)

Pitanja o ovom artiklu

How much power does the 1.20V DDR4 2400 module draw under continuous server load?

It runs at the standard 1.20V DDR4 voltage; actual power draw depends on the platform and workload, but the module is rated for that voltage.

Does my motherboard need to support registered ECC DDR4 RDIMMs for this 288-pin stick to work?

Yes, the module is a registered ECC RDIMM and requires a platform that accepts registered DDR4 memory with ECC.

Can I mix this PC4-19200 CL17 RDIMM with other DDR4 RDIMMs of different speeds or ranks in the same system?

Mixing speeds or ranks is possible only if the platform supports it; the memory controller will typically run all modules at the lowest common speed and timing.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.