Brute Networks
Brute Networks 16GB DDR4-2400 CL15 2Rx8 1.2V Non-ECC UDIMM
16 GB DDR4-2400 CL15 2Rx8 non-ECC UDIMM at 1.2 V for HP Z9H57AT compatible servers
- Capacity16GB
- Type288-Pin DDR4 SDRAM
- SpeedDDR4 2400 (PC4 19200)
- CAS LatencyCL15
- Voltage1.20V
- ECCNo
- 16GB capacity runs more apps at once
- DDR4-2400 speed moves data quickly
- CL15 latency keeps response tight
- 2V operation reduces power draw
- 288-pin UDIMM fits standard desktop slots
HP-compatible 16 GB DDR4 module
This 16 GB DDR4-2400 UDIMM matches HP part number Z9H57AT and runs at CL15 with 1.20 V. It uses a 288-pin unregistered layout and a 2Rx8 organisation built from major-brand chips. The module is sold new and carries a lifetime warranty from the vendor.
Builders adding capacity to HP servers
The stick suits administrators expanding memory in compatible HP platforms that accept non-ECC DDR4-2400 UDIMMs. It will not help buyers who need registered or load-reduced modules, nor those who require ECC error correction for data-integrity workloads. Systems limited to lower speeds or different pin counts cannot use this part.
Fits standard DDR4 UDIMM slots
Installation requires an available 288-pin DDR4 slot that supports 1.20 V unbuffered memory at 2400 MT/s. The single rank-per-channel 2Rx8 design leaves other slots free for additional modules of the same specification. No extra power cables, cooling or BIOS updates are mentioned in the supplied data.
Istaknuto
- 16GB capacity runs more apps at once
- DDR4-2400 speed moves data quickly
- CL15 latency keeps response tight
- 2V operation reduces power draw
- 288-pin UDIMM fits standard desktop slots
Specifikacije
| Brand | HP |
|---|---|
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unregistered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
Pitanja o ovom artiklu
My motherboard has 288-pin DDR4 slots — does this 288-pin UDIMM fit directly?
Yes, the module uses the standard 288-pin DDR4 UDIMM form factor, so it installs directly into any desktop or server board with matching DDR4 slots.
If I add this CL15 2400 MHz stick alongside my current DDR4 modules, what speed will the system run at?
The memory controller will clock all installed modules to the lowest common speed and timing, so this 2400 MHz CL15 stick will run at whatever frequency and latency your existing DDR4 memory dictates.
After installation, how can I confirm the module is recognised as 16 GB at 2400 MHz CL15?
Check the system BIOS or a tool such as CPU-Z; it should report a single 16 GB DDR4 module operating at 2400 MT/s with CAS latency 15 at 1.20 V.
Također u ovoj kategoriji
Kupci su usporedili ovo
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.



