DELL
DELL 028J2 4TB 3.5" SAS 7200 RPM internal hard drive
A 4TB 3.5-inch SAS hard drive spinning at 7200 RPM with a 12Gb/s interface for Dell servers
- PackagingBare Drive
- InterfaceSAS 12Gb/s
- Capacity4TB
- RPM7200 RPM
- Average Latency12Gb/s
- Form Factor3.5"
- 4 TB capacity stores large data sets
- 7200 RPM spindle speed delivers responsive throughput
- SAS 12 Gb/s interface enables fast host transfers
- 5 inch form factor fits standard drive bays
- New condition provides full manufacturer reliability
Dell 028J2 4TB SAS Hard Drive
The Dell 028J2 is a new 3.5-inch internal hard drive with a 4TB capacity. It operates at 7200 RPM using a SAS 12Gb/s interface. The bare drive ships without retail packaging and includes a tray for installation in compatible Dell PowerEdge and PowerVault servers.
Suited for server storage expansion
This drive fits administrators expanding storage arrays in Dell servers that accept 3.5-inch SAS drives with a tray. The 7200 RPM spindle speed supports general-purpose workloads. Buyers whose controllers only support 6Gb/s SAS or 3Gb/s SAS speeds should verify compatibility before purchasing.
SAS 12Gb/s interface
The drive connects via a SAS 12Gb/s interface, which determines the maximum data transfer rate to the host controller. This specification is the primary factor for matching the drive to a supported backplane or RAID card. Systems limited to lower SAS link speeds may not utilise the full interface bandwidth.
Istaknuto
- 4 TB capacity stores large data sets
- 7200 RPM spindle speed delivers responsive throughput
- SAS 12 Gb/s interface enables fast host transfers
- 5 inch form factor fits standard drive bays
- New condition provides full manufacturer reliability
Specifikacije
| Brand | Dell |
|---|---|
| Model | 028J2 |
| Packaging | Bare Drive |
| Interface | SAS 12Gb/s |
| Capacity | 4TB |
| RPM | 7200 RPM |
| Average Latency | 12Gb/s |
| Form Factor | 3.5" |
Pitanja o ovom artiklu
How much power does the 7200 RPM SAS drive draw during continuous operation?
The 4 TB 3.5" SAS drive spins at 7200 RPM and uses a 12 Gb/s interface for sustained all-day workloads.
Which controller or backplane is required to run this 12 Gb/s SAS drive?
A SAS controller or server backplane that supports 12 Gb/s SAS connectivity is needed for the drive to function.
Will this 12 Gb/s SAS drive work in a PowerEdge server that only has 6 Gb/s SAS backplanes?
The drive negotiates down to 6 Gb/s on older backplanes, so it operates normally in earlier PowerEdge and PowerVault systems.
Također u ovoj kategoriji
Kupci su usporedili ovo
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
