Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Rectangular metal AT power supply unit, matte finish

KHACHIMO

KHACHIMO AT Power Supply 300W SPI-300G SD-250AT

SKU CH-9VG6-6VCD3

AT power supply delivering 300 watts for P8 and P9 systems

  • TypeATX
  • 300 W output powers legacy AT systems
  • 250 W continuous rating supports stable operation
  • ATX form factor fits standard chassis
  • Tested working for reliable performance

Compatible AT power supply for legacy systems

This 300 W AT-type unit carries the SPI-300G and SD-250AT designations and is tested working before dispatch. It is intended for older PCs that still use the P8 and P9 motherboard connectors rather than modern ATX plugs.

P8 and P9 connectors replace standard ATX headers

The bundled wiring harness provides the two six-pin blocks required by classic AT mainboards, removing the need for adapters. Builders working on vintage hardware can install the unit directly, while anyone with a current ATX board will find the connector layout unsuitable.

Istaknuto

  • 300 W output powers legacy AT systems
  • 250 W continuous rating supports stable operation
  • ATX form factor fits standard chassis
  • Tested working for reliable performance

Specifikacije

TypeATX

Pitanja o ovom artiklu

Will the internal fan need periodic cleaning or eventual replacement on the SPI-300G?

The 300 W AT supply uses a standard cooling fan; dust buildup should be cleared every few months and the fan itself typically lasts several years before bearing wear requires a swap.

Which limit appears first when the SD-250AT runs continuously at full load?

The 250 W continuous rating is reached before the 300 W peak, so sustained output is capped at the lower figure and the protection circuit will engage if that level is exceeded.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.