Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Green bare circuit board with gold edge connectors and black memory chips no heat spreader

NEMIX RAM

NEMIX RAM 96GB DDR5 6400 CL52 2Rx4 1.1V ECC Registered RDIMM Supermicro X14QBH+ memory upgrade

SKU CH-ZCMQ-HCF1Q

96 GB DDR5-6400 registered ECC RDIMM with CL52 latency, 1.1 V operation and 2Rx4 organisation, validated for the Supermicro X14QBH+ motherboard

  • Capacity96GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes

Size 96GB

Prikaži još 8 konfiguracija
  • 96 GB capacity lets the Supermicro X14QBH+ run fully populated at rated speed
  • DDR5 6400 PC5-51200 matches the board's memory controller timing exactly
  • Registered ECC 2Rx4 design offloads the controller and corrects single-bit errors on the fly
  • 1 V operation meets the platform's voltage spec for stable enterprise workloads
  • 288-pin RDIMM form factor fits the required slot type without adapters

Targeted Server Upgrade

This 96GB DDR5 module is built as an exact-match upgrade for the Supermicro X14QBH+ motherboard. It delivers registered ECC memory in a 288-pin RDIMM form factor that the board requires for full-capacity recognition at rated speed.

DDR5 Registered Limits

DDR5 registered DIMMs use a buffered architecture so the memory controller can drive every populated slot at 6400 MT/s without signal degradation. The 2Rx4 organisation and 1.1V operation are fixed by the standard; mixing different ranks or voltages will prevent the system from training at the rated frequency.

Pre-Install Checks

Consult the motherboard manual for the approved DIMM population order and maximum supported capacity per slot before ordering. Verify that the firmware version installed on your X14QBH+ board lists this part number in its qualified vendor list to avoid a no-post condition.

Istaknuto

  • 96 GB capacity lets the Supermicro X14QBH+ run fully populated at rated speed
  • DDR5 6400 PC5-51200 matches the board's memory controller timing exactly
  • Registered ECC 2Rx4 design offloads the controller and corrects single-bit errors on the fly
  • 1 V operation meets the platform's voltage spec for stable enterprise workloads
  • 288-pin RDIMM form factor fits the required slot type without adapters

Specifikacije

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-9624K1
Capacity96GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content96GB DDR5 6400MHz PC5-51200 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Druge verzije ovog modela

još 5 u istoj seriji

Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.

Pitanja o ovom artiklu

Is this 96GB DDR5 6400 CL52 2Rx4 1.1V ECC Registered RDIMM the only capacity and speed available for the Supermicro X14QBH+?

This listing supplies a single 96GB module rated at DDR5 6400 with CL52 latency, 1.1V operation and 2Rx4 registered ECC. Other capacities or speeds would be separate part numbers not covered here.

Will the DDR5 6400 (PC5-51200) rating actually run at 6400 MT/s once installed in the X14QBH+?

The module is specced to DDR5 6400 (PC5-51200) at CL52 and 1.1V. The X14QBH+ memory controller must support that data rate and the registered ECC 2Rx4 configuration for the DIMM to operate at its rated speed.

Does the 288-pin RDIMM form factor and registered ECC design limit which slots I can populate on the X14QBH+?

The 288-pin Registered DIMM with ECC is the exact form factor the X14QBH+ requires. Population order and maximum supported capacity per slot are defined in the motherboard manual, so consult it before installing.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.