Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Two green DDR4 UDIMM sticks, black chips, no heat spreader, gold contacts

NEMIX RAM

NEMIX RAM DDR4 3200 ECC UDIMM 64GB (2x32GB) CL22 1.2V 2Rx8 288-pin memory upgrade

SKU CH-RD44-H4RE1

64 GB DDR4 ECC UDIMM kit running at 3200 MHz CL22 1.2 V for Supermicro X12STE-F and X12STD-F boards

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR4 ECC UDIMM
  • SpeedDDR4 3200 (PC4 25600)
  • CAS LatencyCL22
  • Voltage1.20V
  • ECCYes

Size 64GB 2X32GB

  • 64 GB kit (2 × 32 GB) doubles system capacity for heavy workloads
  • DDR4-3200 (PC4-25600) speed matches the controller spec so modules run at rated frequency
  • ECC UDIMM detects and corrects single-bit errors on the fly preventing silent data corruption
  • 20 V CL22 2Rx8 timing is the exact rank, voltage and latency the board expects for full recognition
  • Validated for Supermicro X12STE-F and X12STD-F motherboards ensuring correct 288-pin unbuffered fit

Exact-Match DDR4 ECC Kit

This NEMIX RAM kit delivers 64 GB of DDR4-3200 ECC UDIMM memory in a matched pair of 32 GB modules. It is built for workstations and servers that require error-correcting code to protect data integrity during continuous operation. The unbuffered design suits motherboards that do not accept registered DIMMs.

Verify Board Population Rules

Before ordering, consult the Supermicro X12STE-F or X12STD-F manual for supported capacities, approved DIMM population order, and voltage requirements. The kit uses 2Rx8 organization at 1.20 V and 288-pin UDIMM form factor, which must match the board's memory-controller expectations. Installing modules in the wrong slots or exceeding the validated capacity can prevent boot or limit speed.

Sustained Load Stability

Under sustained load, ECC circuitry continuously detects and corrects single-bit errors to prevent silent data corruption and unplanned reboots. The CL22 timing and standard 1.20 V operation keep power draw predictable during long compute runs. Without a heat spreader, adequate case airflow is necessary to maintain rated performance over extended periods.

Istaknuto

  • 64 GB kit (2 × 32 GB) doubles system capacity for heavy workloads
  • DDR4-3200 (PC4-25600) speed matches the controller spec so modules run at rated frequency
  • ECC UDIMM detects and corrects single-bit errors on the fly preventing silent data corruption
  • 20 V CL22 2Rx8 timing is the exact rank, voltage and latency the board expects for full recognition
  • Validated for Supermicro X12STE-F and X12STD-F motherboards ensuring correct 288-pin unbuffered fit

Specifikacije

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR4 ECC Unbuffered UDIMM Memory
Part NumberME25600-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR4 ECC UDIMM
SpeedDDR4 3200 (PC4 25600)
CAS LatencyCL22
Voltage1.20V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR4 ECC Unbuffered UDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR4 3200MHz PC4-25600 2Rx8 1.2V 288-PIN ECC UDIMM KIT

Druge verzije ovog modela

još 5 u istoj seriji

Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.

Pitanja o ovom artiklu

What comes inside the 64GB kit and do I need anything else to install it?

The kit contains two 32GB DDR4 3200MHz PC4-25600 2Rx8 1.2V CL22 288-pin ECC UDIMM modules. No extra parts are required for installation into a compatible Supermicro motherboard.

Should I choose this 64GB (2x32GB) kit or a different capacity for my Supermicro X12STE-F or X12STD-F?

This 64GB kit uses two 32GB 2Rx8 ECC UDIMMs that match the board's DDR4 3200 PC4-25600 specification. Select it when your workload needs 64GB total and your motherboard manual confirms two-DIMM population at that capacity.

What does the CL22 rating mean when the memory is running in my Supermicro system?

CL22 is the CAS latency at DDR4 3200 (PC4-25600). The memory controller will operate the kit at 1.2V with 22 clock cycles of column access delay, delivering the rated ECC error-correction and throughput for the X12STE-F or X12STD-F platform.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.