Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Six green circuit boards with black chips in anti-static tray

NEMIX RAM

NEMIX RAM DDR5 4800 ECC Registered RDIMM 192GB (6x32GB) CL40 1.1V 288-Pin memory upgrade for Supermicro H13SSH

SKU CH-S2TE-WDXJN

192GB DDR5 4800 ECC Registered RDIMM kit in six 32GB modules at CL40 and 1.1V for Supermicro H13SSH

  • Capacity192GB (6 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 192GB 6X32GB

Prikaži još 30 konfiguracija
  • 192 GB total capacity from six 32 GB modules
  • DDR5-4800 speed with CL40 latency at 1.1 V
  • Registered ECC architecture for error correction and stability
  • 288-pin RDIMM form factor matched to Supermicro H13SSH
  • Major-brand DRAM chips from Samsung, Micron or Hynix

Exact-fit DDR5-4800 RDIMM kit

This 192GB kit contains six 32GB DDR5-4800 Registered ECC modules built to the Supermicro H13SSH memory specification. The 2Rx8 organization, 1.10V operating voltage and CL40 timing match the controller requirements so the system recognizes full capacity at rated speed. It is intended for administrators who need maximum supported memory in that specific platform.

Upgrading from partial or slower populations

Replacing a smaller or mixed-capacity installation with this matched six-module kit eliminates population-rule conflicts and lets every channel run at DDR5-4800. The jump is worth it when the workload requires the full 192GB address space and the board's qualified-vendor list calls for 2Rx8 Registered DIMMs at 1.10V. Builders using UDIMMs, SODIMMs or different rank configurations cannot use this kit.

Registered DDR5 interface constraints

The Registered architecture buffers address and command signals so the memory controller can drive all slots at the rated data rate, while on-die ECC corrects single-bit errors before they reach the CPU. DDR5-4800 (PC5-38400) sets the maximum transfer rate; the platform cannot exceed this speed regardless of module headroom. Systems that require unbuffered DIMMs, a different pin count, or a lower voltage standard are incompatible.

Istaknuto

  • 192 GB total capacity from six 32 GB modules
  • DDR5-4800 speed with CL40 latency at 1.1 V
  • Registered ECC architecture for error correction and stability
  • 288-pin RDIMM form factor matched to Supermicro H13SSH
  • Major-brand DRAM chips from Samsung, Micron or Hynix

Specifikacije

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-328K6
Capacity192GB (6 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content192GB 6X32GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Druge verzije ovog modela

još 5 u istoj seriji

Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.

Pitanja o ovom artiklu

Will the 288-pin RDIMM modules fit the Supermicro H13SSH memory slots?

Yes. The kit uses the 288-pin DDR5 RDIMM form factor that the H13SSH requires, not a UDIMM or SODIMM, so each module seats in the board's standard DIMM slots.

What is the correct population order for the six 32 GB sticks on the H13SSH?

Install the modules in the exact slot sequence listed in the Supermicro H13SSH manual; the board's memory-population rules dictate which of the 13 slots must be filled first for the 192 GB kit to be recognised at full speed.

Do these Registered ECC modules need any firmware updates or periodic replacement?

No firmware updates are required for the memory itself; the ECC and registered design run continuously without wear-out maintenance, and the sticks are replaced only if a hardware failure occurs.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.