Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Two green DDR5 RDIMM modules with gold contacts and black chips, no heat spreaders

NEMIX RAM

NEMIX RAM DDR5 64GB 2x32GB 4800MHz CL40 ECC Registered RDIMM Supermicro H14SSL-N memory upgrade

SKU CH-1QVH-8ZJZ8

A 64 GB kit of two 32 GB DDR5 4800 MHz CL40 ECC registered RDIMMs at 1.1 V, validated for the Supermicro H14SSL-N motherboard

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 64GB 2X32GB

Prikaži još 24 konfiguracija
  • 64 GB capacity from a matched 2×32 GB kit for full server density
  • DDR5-4800 speed with CL40 timing runs at rated frequency on the Supermicro H14SSL-N
  • Registered ECC architecture corrects single-bit errors and buffers every slot for stable full-population operation
  • 10 V low-voltage DDR5 modules reduce power draw while meeting the board's exact electrical spec
  • 288-pin RDIMM form factor fits the H14SSL-N memory slots without adapters or mismatches

Supermicro H14SSL-N DDR5 RDIMM kit

This NEMIX RAM kit delivers 64 GB of DDR5 ECC Registered memory in a matched pair of 32 GB modules. It operates at 4800 MT/s with CL40 latency at 1.1 V using the 288-pin RDIMM form factor required by the Supermicro H14SSL-N motherboard. The 2Rx8 organisation and registered design satisfy the board's population rules for full-capacity operation.

Suited for servers needing registered ECC memory

The registered architecture and on-die ECC make this kit appropriate for workloads that demand error correction and signal integrity across fully populated slots. It is not intended for platforms that accept only unbuffered UDIMMs or SODIMMs, nor for systems limited to lower DDR5 speeds or different pin counts. Buyers who need higher capacities per module or lower latencies should verify their board's qualified-vendor list first.

Fits 288-pin RDIMM slots on the H14SSL-N

Each module slots directly into the motherboard's DDR5 RDIMM sockets without adapters or converters. The 1.1 V operating voltage matches the platform's native rail, leaving headroom for the CPU memory controller when all channels are filled. Confirm the manual's population order before installation to ensure the controller initialises every rank at the rated 4800 MT/s.

Istaknuto

  • 64 GB capacity from a matched 2×32 GB kit for full server density
  • DDR5-4800 speed with CL40 timing runs at rated frequency on the Supermicro H14SSL-N
  • Registered ECC architecture corrects single-bit errors and buffers every slot for stable full-population operation
  • 10 V low-voltage DDR5 modules reduce power draw while meeting the board's exact electrical spec
  • 288-pin RDIMM form factor fits the H14SSL-N memory slots without adapters or mismatches

Specifikacije

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Druge verzije ovog modela

još 5 u istoj seriji

Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.

Pitanja o ovom artiklu

Do I need a motherboard with 288-pin DDR5 RDIMM slots to install this 64GB kit?

Yes, the kit uses 288-pin DDR5 RDIMM modules that require a board designed for registered ECC memory, such as the Supermicro H14SSL-N.

Will the registered ECC design of these DIMMs let me fully populate the H14SSL-N without signal-loading issues?

The registered architecture buffers address and command signals, allowing every slot to run at the rated 4800 MHz speed even when all channels are filled.

How can I confirm the memory is running at 4800 MHz with CL40 timing after installation?

Check the BIOS memory information screen or run a tool such as dmidecode to verify the reported speed of 4800 MT/s and CAS latency of 40 cycles.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.