Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Silver aluminium solar panel tilt bracket kit with adjustable 0°-90° angle and 1180 mm rails

PFCTART

PFCTART 118CM solar panel adjustable tilt mount bracket 1180 mm 0°-90°

SKU CH-3FJ3-3PSWH MPN 118CM

Adjustable 0°-90° aluminium bracket set holds 1180 mm solar panels for maximum sun exposure and up to 40% more output

  • TypeMounts
  • Cell TypeMonocrystalline
  • Solar Panel KitsOff-Grid
  • Solar InvertersOff-Grid Inverters
  • Size/Dimensions1180 mm
  • ConnectorsDC
  • Adjustable 0°-90° tilt captures maximum sunlight
  • Aluminum alloy frame resists corrosion and weather
  • Increases energy yield by 15%-40% with optimal angle
  • Simple assembly suits DIY and professional installs
  • Complete kit includes rails brackets and stainless hardware

Adjustable tilt bracket for solar panels

The PFCTART 118CM bracket sets the panel angle between 0° and 90° so the array faces the sun through the day. It suits off-grid installations on roof or ground where seasonal re-tilting is practical. The kit includes rails, angle brackets and all fasteners for a single mounting job.

Steady output through wind and snow

Aluminium alloy rails with anodised or hot-dip galvanised finish resist corrosion while holding the module firm against wind and snow loads. The structure keeps the panel at the chosen angle so daily generation stays consistent instead of dropping when weather shifts the array.

Aluminium rails with stainless hardware

Each long leg measures 1180 mm and each short leg 545 mm, both using 30×30×2.5 mm angle profile. The package supplies eight rails, four tilt brackets and sets of steel flange nuts, lock washers, hex bolts, wing nuts and self-tapping screws plus plastic retaining rings for a complete bolt-together assembly.

Istaknuto

  • Adjustable 0°-90° tilt captures maximum sunlight
  • Aluminum alloy frame resists corrosion and weather
  • Increases energy yield by 15%-40% with optimal angle
  • Simple assembly suits DIY and professional installs
  • Complete kit includes rails brackets and stainless hardware

Specifikacije

BrandPFCTART
ModelSolar Panel Mount Brackets
TypeMounts
Cell TypeMonocrystalline
Solar Panel KitsOff-Grid
Solar InvertersOff-Grid Inverters
Size/Dimensions1180 mm
ConnectorsDC
NOCT Optimum Operating Current (Imp)Greater Than 10 A
SpecificationsSolar Panel Kit
FeaturesCorrosion Resistant
Sports TeamOutdoor
Sports Leaguesolar

Pitanja o ovom artiklu

Does the 1180 mm aluminum bracket generate any noise or heat when mounted outdoors all day?

The bracket is a passive aluminum structure with no moving parts, so it produces no noise and no heat of its own during continuous outdoor use.

What solar panels and tools must I already own to install this tilt mount?

You need compatible solar panels with mounting holes that match the 30×30 mm rails, plus basic hand tools for the supplied M8 bolts, wing nuts and self-tapping screws.

Will this 0°-90° adjustable mount work with the older 545 mm short-leg brackets I already have?

Yes, the kit includes both 1180 mm long legs and 545 mm short legs, so it can replace or extend an existing setup using the same 30×30×2.5 mm profile.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.