Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Grey ATX power supply unit with single fan and multiple cables

Replace Power

Replace Power RPSU-C99-59 420W ATX power supply

SKU CH-X3KW-94H3W MPN RPSU-C99-59

420W ATX replacement supply for eMachines T4892, T5010, T5016, T5020, T5022, T5026 with 20+4 ATX, ATX12V, SATA and peripheral connectors, switchable 110V/220V input and 80mm cooling

  • ColorGrey
  • TypeATX
  • Fans1
  • Weight0.1
  • 420W output powers compatible eMachines desktops reliably
  • Switchable 110V or 220V input suits global mains voltages
  • 80mm fan provides active cooling for stable operation
  • ATX form factor with 20+4 pin and 12V connectors fits standard cases
  • Includes SATA, peripheral and floppy power cables for drives

Replacement PSU for eMachines T4892 T5010 T5016

This 420W ATX unit from Replace Power is built as a direct replacement for the listed eMachines desktops. It uses a standard ATX form factor and a single 80mm fan for cooling. The grey housing fits the original chassis without modification. It targets owners restoring or repairing those specific legacy systems.

Sustained delivery at 420W with switchable input

The supply accepts both 110V and 220V input via a manual switch, allowing use in different regions. Under continuous load the single fan maintains airflow across the power module. The 420W rating represents the sustained output capacity rather than a peak figure. Stable rails support typical desktop workloads over long sessions.

Connector set determines compatibility

The loom includes one 15-inch SATA connector, one 14-inch 20+4 pin ATX connector, one 14-inch 12V ATX connector, two 15-inch large peripheral connectors, two 6-inch large peripheral connectors and one 6-inch small peripheral connector. This exact mix decides whether the unit matches the motherboard and drive layout of the target machine. Builders needing additional SATA or PCIe leads cannot use this model.

Istaknuto

  • 420W output powers compatible eMachines desktops reliably
  • Switchable 110V or 220V input suits global mains voltages
  • 80mm fan provides active cooling for stable operation
  • ATX form factor with 20+4 pin and 12V connectors fits standard cases
  • Includes SATA, peripheral and floppy power cables for drives

Specifikacije

BrandReplace Power
ModelRPSU-C99-59
ColorGrey
TypeATX
Fans1
Weight0.1

Pitanja o ovom artiklu

How loud is the 80 mm fan when the 420 W unit runs continuously?

The single 80 mm fan spins at a constant speed to move air through the chassis; expect a steady low hum typical of budget ATX supplies under load.

Which existing cables or connectors must my motherboard already provide for this replacement to work?

Your board needs a 20- or 24-pin ATX socket plus a 12 V ATX12V plug; the supply includes both on fixed 14-inch leads.

Will the 15-inch SATA lead reach drives in a full-size tower case?

The SATA connector is on a 15-inch cable, long enough for mid-tower bays but may fall short in full-tower bottom-mount layouts.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.