Supermicro
Supermicro X6DHE-G2 server motherboard, dual Xeon 604-pin, 8× DDR2 400, E7520
Dual 604-pin Xeon server board with eight DDR2 400 slots for 16 GB ECC memory, onboard ATI Rage XL video, SATA RAID and Intel E7520 chipset
- Supports dual Xeon processors for multi-threaded server workloads
- Eight DDR2 400 DIMM slots enable up to 16 GB registered ECC memory
- Intel E7520 chipset with 800 MHz system bus and ICH5R SATA
- Onboard ATI Rage XL graphics with 8 MB video memory
- Phoenix BIOS in 8 Mb flash EEPROM for firmware management
Dual-Socket Server Board
The Supermicro X6DHE-G2 is a dual-socket server motherboard built for dual 604-pin Xeon processors. It targets system integrators maintaining legacy 800 MHz front-side-bus platforms or replacing failed boards in existing E7520-based infrastructure.
Memory and I/O Constraints
Eight 240-pin DIMM slots accept registered ECC DDR2 400 modules at 1.8 V up to 16 GB total. Onboard video uses an ATI Rage XL controller with 8 MB memory; storage and networking run through the ICH5R SATA and Intel 82546GB Gigabit LAN interfaces.
Pre-Installation Checklist
Verify that your chassis accepts an E-ATX form factor and that the power supply delivers the required EPS12V connectors for dual CPUs. Confirm you have registered ECC DDR2 400 DIMMs in supported 256 MB, 512 MB, 1 GB or 2 GB capacities, as unbuffered or faster memory will not function.
Istaknuto
- Supports dual Xeon processors for multi-threaded server workloads
- Eight DDR2 400 DIMM slots enable up to 16 GB registered ECC memory
- Intel E7520 chipset with 800 MHz system bus and ICH5R SATA
- Onboard ATI Rage XL graphics with 8 MB video memory
- Phoenix BIOS in 8 Mb flash EEPROM for firmware management
Specifikacije
Za ovaj artikl još nisu objavljene specifikacije.
Pitanja o ovom artiklu
Should I populate all eight DDR2 400 slots or start with a smaller matched set?
The board accepts up to 16 GB using eight 240-pin buffered ECC DIMMs at 1.8 V; populate in matched pairs for best stability.
What does the 800 MHz system bus deliver for dual Xeon 604-pin CPUs?
It provides 800 MT/s per processor link, giving balanced bandwidth between the two sockets and the E7520 memory controller.
How does the onboard SATA controller from the ICH5R connect to drives?
The ICH5R supplies native SATA ports with RAID 0, 1, 5 support for internal hard drives or SSDs.
Također u ovoj kategoriji
Kupci su usporedili ovo
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Transition Networks ION106-AAB-NA 6 Slot AC Ion Server Chassis Redundant Power Supply
Supermicro SNK-P0048PSC 2U Passive CPU Heatsink LGA2011 Xeon E5-2600
Supermicro MCP-260-00085-0B 1U I/O shield for A1SRM-LN7F/LN5F in SC510 server chassis
- Rear Panel



