A-Tech 16GB (2x8GB) DDR3 1066MHz PC3-8500 CL7 1.5V 240-Pin Desktop RAM
- 16GB (2 x 8GB)
- 240-Pin PC RAM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
A-Tech
A 16GB dual-channel DDR3 kit running at 1600MHz with CL11 latency and 1.5V operation for compatible desktop systems
Capacity 16GB (2 x 8GB)
Speed DDR3 1600 (PC3 12800)
This kit contains two 8GB unbuffered DIMMs that together provide 16GB of DDR3 memory for desktop systems. Each module operates at 1.5V and uses the standard 240-pin form factor. It is intended for computers that support DDR3 technology.
The modules are rated for 1600MHz operation with a CAS latency of 11, corresponding to the PC3-12800 bandwidth classification. This single specification determines whether the memory matches the motherboard's supported speed and timing requirements. Verify your system documentation for DDR3 1600 compatibility before purchase.
Each 8GB stick uses a dual-rank 2Rx8 configuration, which affects how the memory controller addresses the chips. This organisation can influence maximum supported capacity per slot on some platforms. The kit includes only the two memory modules; no additional accessories or software are bundled.
| Brand | A-Tech |
|---|---|
| Capacity | 16GB (2 x 8GB) |
| Speed | DDR3 1600 (PC3 12800) |
| Tested Frequency | 1600 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Recommend Use | Select Compatible DDR3 Desktops |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
The kit runs at 1600 MHz with CL11 latency, giving standard DDR3 bandwidth for everyday multitasking and application loading on compatible systems.
PC3-12800 confirms the modules are validated for 1600 MHz operation; the motherboard will not exceed this data rate without manual overclocking.
Yes, the 240-pin unbuffered DIMM form factor matches standard desktop DDR3 slots; verify your board supports 1.5 V dual-rank modules before installing.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?