NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
A-Tech
A 16 GB DDR4 2133 MHz ECC registered DIMM with dual-rank chips, Supermicro certified for server reliability
This 16GB DDR4 2133MHz module is built for servers and workstations that require error-correcting registered memory. It uses a 2Rx4 dual-rank layout and runs at the standard 1.20V voltage. The stick carries Supermicro certification for the MEM-DR416L-HL01-ER21 part number.
At CL15 latency the module delivers consistent throughput during extended workloads rather than only in short bursts. Registered buffering reduces electrical load on the memory controller, helping stability when all slots are populated. ECC circuitry corrects single-bit errors on the fly to prevent data corruption over long runs.
Verify that your motherboard supports DDR4 RDIMM modules at 2133MHz with ECC registered operation. The 288-pin form factor fits standard DDR4 server slots, but some consumer boards cannot use registered memory. Confirm the maximum supported capacity per slot and total population rules in your system documentation.
| Brand | SuperMicro |
|---|---|
| Series | Supermicro Certified |
| Model | MEM-DR416L-HL01-ER21 |
| Capacity | 16GB |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Supermicro Certified MEM-DR416L-HL01-ER21 (HMA42GR7MFR4N-TF) |
At the standard 1.20V DDR4 voltage the 16GB RDIMM operates within normal server memory power envelopes; exact sustained draw depends on workload and platform but no elevated voltage is required.
The board must provide DDR4 RDIMM slots that support ECC Registered memory and accept 2Rx4 modules at 2133MHz.
It can run with other DDR4 2133MHz ECC Registered DIMMs, though mixing ranks or CAS latencies may force the system to the slowest common timing.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?