SK hynix HMA42GR7AFR4N-TF 16GB DDR4 2133MHz CL15 ECC Registered Dual Rank 1.2V 288-Pin Server RAM
- 16GB
- 288-Pin DDR4 SDRAM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A-Tech
A 16 GB DDR4 2133 MHz ECC registered DIMM with dual-rank chips, Supermicro certified for server reliability
This 16GB DDR4 2133MHz module is built for servers and workstations that require error-correcting registered memory. It uses a 2Rx4 dual-rank layout and runs at the standard 1.20V voltage. The stick carries Supermicro certification for the MEM-DR416L-HL01-ER21 part number.
At CL15 latency the module delivers consistent throughput during extended workloads rather than only in short bursts. Registered buffering reduces electrical load on the memory controller, helping stability when all slots are populated. ECC circuitry corrects single-bit errors on the fly to prevent data corruption over long runs.
Verify that your motherboard supports DDR4 RDIMM modules at 2133MHz with ECC registered operation. The 288-pin form factor fits standard DDR4 server slots, but some consumer boards cannot use registered memory. Confirm the maximum supported capacity per slot and total population rules in your system documentation.
| Brand | SuperMicro |
|---|---|
| Series | Supermicro Certified |
| Model | MEM-DR416L-HL01-ER21 |
| Capacity | 16GB |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Supermicro Certified MEM-DR416L-HL01-ER21 (HMA42GR7MFR4N-TF) |
At the standard 1.20V DDR4 voltage the 16GB RDIMM operates within normal server memory power envelopes; exact sustained draw depends on workload and platform but no elevated voltage is required.
The board must provide DDR4 RDIMM slots that support ECC Registered memory and accept 2Rx4 modules at 2133MHz.
It can run with other DDR4 2133MHz ECC Registered DIMMs, though mixing ranks or CAS latencies may force the system to the slowest common timing.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?