NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
A-Tech
4GB DDR3 1066MHz ECC registered DIMM with 2Rx8 organisation for server and workstation upgrades
This A-Tech module adds 4GB of registered ECC memory to compatible servers and workstations. It uses a 240-pin DDR3 DIMM form factor and is built as a direct replacement for the Samsung M393B5273BH1-CF8 part. The 2Rx8 organisation and major-brand chips are intended for systems that require error correction and registered buffering.
DDR3 1066 (PC3-8500) tops out at 1066 MT/s with a standard 1.5V supply, so bandwidth is capped at the PC3-8500 level. Registered signalling adds one clock cycle of latency, and the platform's memory controller determines the maximum usable capacity and populated slot count. Mixing speeds will force all modules to run at the lowest common rate.
The module is an ECC RDIMM, so it only works in systems whose chipset and BIOS explicitly support registered error-correcting memory. Desktop or consumer boards that accept only unbuffered non-ECC DIMMs will not recognise it. Verify the platform's qualified-vendor list before purchase.
| Brand | A-Tech |
|---|---|
| Capacity | 4GB |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
This module provides 4GB in a single 240-pin DDR3 ECC RDIMM running at 1066MHz. Select it when your system requires registered ECC memory at that speed and you need a 4GB increment.
PC3-8500 is the JEDEC designation for DDR3 1066MHz memory. Your actual throughput depends on the platform's memory controller and how many channels it populates.
The 240-pin DDR3 form factor carries the 1066MHz signal. The registered buffer and ECC logic operate at that frequency, so the interface itself does not impose a lower cap.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?