BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
NEMIX RAM
16 GB DDR4 2666 CL19 1.2 V 288-pin UDIMM upgrades desktop memory capacity and speed
This 16GB DDR4 UDIMM runs at 2666 MT/s with CL19 latency and 1.20 V operation. It uses a 288-pin unbuffered non-ECC design built with major OEM chips from Samsung Micron or Hynix. The module targets desktop PC upgrades and standard workloads. No heat spreader or LED lighting is included.
The stick installs in any desktop board that accepts 288-pin DDR4 UDIMM memory at 1.20 V. It requires no extra power cables or cooling hardware and leaves all expansion slots free. Compatibility is validated through stress testing under load. The single 16GB rank lets you populate remaining slots later.
Home office users and IT professionals seeking reliable capacity for productivity tasks will find this module a direct fit. Enthusiasts chasing higher frequencies lower latencies or RGB aesthetics should evaluate other kits. ECC or registered server platforms are not supported by this unbuffered non-ECC design.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM DDR4 Orignial Desktop PC 288-Pin Non-ECC Unbuffered UDIMM Memory |
| Model | Original Series DDR4 Desktop PC Memory Solutions |
| Part Number | MD21300-628K1 |
| Capacity | 16GB |
| Type | 288-Pin DDR4 UDIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Features | DDR4 Non-ECC Unbuffered UDIMM Motherboard Compatible |
| LED Color | None |
The module is a standard 288-pin DDR4 UDIMM. It fits any desktop board with a DDR4 UDIMM slot that supports 2666 MT/s at 1.20 V.
The module runs at JEDEC 2666 MT/s CL19 1.20 V by default. No XMP or manual timing entry is needed unless the board forces a lower speed.
Yes. Match the DDR4 2666 MT/s 1.20 V spec. The board will run both in single-channel or flex-mode depending on slot population.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?