OWC 32GB DDR4 2666MHz CL19 1.2V 288-pin UDIMM desktop RAM
- 32GB
- DDR4 2666 (PC4 2130…
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
OWC
32 GB DDR4 3200 CL22 UDIMM for Dell OptiPlex 3000, 5000 and 5080 desktops
This OWC 32GB DDR4 3200 CL22 module is built for Dell OptiPlex 3000, 5000 and 5080 systems in both small form factor and tower chassis. It targets owners of those specific workstations who need a straightforward capacity increase without compatibility guesswork.
The unbuffered non-ECC DIMM runs at 1.2V and slots directly into the motherboard memory sockets of the compatible OptiPlex 3000 SFF, 3000 Tower, 5000 SFF, 5000 Tower and 5080 SFF. It requires no extra cooling, no firmware updates and no additional hardware to operate at its rated PC4-25600 speed.
The module is backward compatible with 2133, 2400, 2666 and 2933MHz DDR4, so it can upgrade existing sticks running at those speeds. The jump is worthwhile when the system currently has less than 32GB total or when installed memory runs below 3200MHz and the board supports the higher rate. It is not for systems that require ECC, registered memory or a different DDR generation.
| Brand | OWC |
|---|---|
| Part Number | 3U2D42R832GB |
| Capacity | 32GB |
| Type | 288-Pin DDR4 Non-ECC UDIMM |
| Speed | DDR4 3200 (PC4 25600) |
| CAS Latency | CL22 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Dell OptiPlex 3000 SFF Dell OptiPlex 3000 Tower Dell OptiPlex 5000 SFF Dell OptiPlex 5000 Tower Dell OptiPlex 5080 SFF |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
CL22 is the rated CAS latency at 3200 MT/s; the module runs at standard JEDEC timings so sustained throughput is determined by the platform memory controller, not by the stick itself.
At 1.2 V with no heat spreader the DRAM stays within normal DDR4 thermal limits; the OptiPlex chassis airflow handles the modest heat load without extra cooling.
The module is unbuffered non-ECC 2Rx8 and works as a single 32 GB DIMM; no matched pair is required for the listed OptiPlex models.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?