Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR4 ECC RDIMM modules, 288-pin, black chips, silver contacts

A-Tech

A-Tech 16GB (2x8GB) DDR4 2400 ECC RDIMM 2Rx8 CL17 1.2V server RAM

SKU CH-K0SC-NFWMA

16 GB dual-channel DDR4 ECC registered DIMM kit running at 2400 MHz with CL17 latency and 1.2 V operation

  • Capacity16GB (2 x 8GB)
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.20V
  • ECCYes
  • Buffered/RegisteredRegistered

Capacity 16GB (2 x 8GB)

  • 16GB dual-channel kit doubles server memory capacity
  • ECC registered DIMM detects and corrects data errors
  • DDR4 2400MHz CL17 delivers responsive workload performance
  • 2V standard voltage reduces power draw per module
  • 288-pin RDIMM form factor fits compatible server boards

Server DDR4 kit

This A-Tech kit supplies 16 GB of DDR4 memory as two 8 GB registered DIMMs built for servers and workstations. It delivers ECC error correction and registered buffering to maintain data integrity under continuous workloads. The modules are not compatible with desktop or laptop platforms.

ECC RDIMM 2Rx8

The decisive specification is the ECC registered dual-rank x8 organisation at DDR4 2400 with CL17 latency and 1.20 V operation. Your system must support DDR4 RDIMM memory with this exact rank and voltage configuration for the kit to function.

288-pin installation

Installation follows standard 288-pin DIMM seating in the correct channel order shown in the system manual. The most common issue is attempting to use these registered ECC modules in a consumer motherboard that only accepts unbuffered non-ECC memory.

Helstu kostir

  • 16GB dual-channel kit doubles server memory capacity
  • ECC registered DIMM detects and corrects data errors
  • DDR4 2400MHz CL17 delivers responsive workload performance
  • 2V standard voltage reduces power draw per module
  • 288-pin RDIMM form factor fits compatible server boards

Tæknilýsing

BrandA-Tech
SeriesA-Tech DDR4 Server Memory RAM
ModelA-Tech 8GB 2Rx8 PC4-2400T-R
Capacity16GB (2 x 8GB)
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
Multi-channel KitDual Channel Kit
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

What does the 2400 MHz speed mean once the modules are installed in a server?

The 2400 MHz rating sets the maximum data rate the memory controller can run; actual throughput depends on the platform's supported speeds and how many DIMMs populate each channel.

How does the registered ECC interface affect usable bandwidth?

Registered ECC adds a clock cycle for the register and uses one bit per byte for error correction, so peak bandwidth is slightly below the raw 19200 MB/s PC4-19200 figure.

What physical slot and clearance do the 288-pin DIMMs need?

They require a standard DDR4 288-pin RDIMM slot; verify your board's DIMM height limit and heater-spreaders before installing the dual-rank modules.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.