Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green 288-pin DDR4 UDIMM with black chips, 16GB ECC server memory module

A-Tech

A-Tech 16GB DDR4 2666MHz ECC UDIMM 2Rx8 Server RAM

SKU CH-EJNW-B4JKE

16 GB DDR4 2666 MHz ECC UDIMM module with CL19 latency and 1.20 V operation

  • Capacity16GB
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.20V
  • ECCYes
  • Buffered/RegisteredUnbuffered
  • 16 GB DDR4 2666 MHz ECC UDIMM for server workloads
  • CL19 latency and 1.20 V voltage for stable operation
  • 2Rx8 dual-rank layout increases memory density
  • 288-pin DDR4 DIMM form factor fits standard server slots
  • Major-brand chipset and chips tested for reliable performance

Capacity and Compatibility

This is a single 16GB DDR4 2666MHz ECC UDIMM module built for server and workstation systems. It uses a 288-pin DIMM form factor and runs at the standard 1.2V voltage with CL19 latency. The module is a direct replacement for Micron part numbers MTA18ADF2G72AZ-2G6 and MTA18ASF2G72AZ-2G6.

Suitable Systems and Limitations

This memory suits administrators upgrading compatible servers or workstations that require ECC unbuffered DDR4 modules. It is not suitable for platforms that only accept registered or load-reduced DIMMs, nor for desktop boards that lack ECC support in the BIOS. Buyers needing higher densities or faster speeds should verify their hardware specifications first.

Installation Notes

Installation follows the standard DIMM slot procedure: align the notch, press firmly until the retention clips engage, and ensure the module is fully seated. The most common issue is purchasing ECC UDIMM for a system that requires registered memory, which will prevent boot. Confirm the exact memory type supported by your motherboard before ordering.

Helstu kostir

  • 16 GB DDR4 2666 MHz ECC UDIMM for server workloads
  • CL19 latency and 1.20 V voltage for stable operation
  • 2Rx8 dual-rank layout increases memory density
  • 288-pin DDR4 DIMM form factor fits standard server slots
  • Major-brand chipset and chips tested for reliable performance

Tæknilýsing

BrandA-Tech
Capacity16GB
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.20V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Spurningar um þessa vöru

What motherboard slot does this 288-pin DDR4 DIMM need to fit and work?

It requires a standard DDR4 UDIMM slot that supports 2666 MHz ECC unbuffered memory at 1.2 V.

Can I mix this 2Rx8 ECC UDIMM with older single-rank DDR4 modules in the same server?

Mixing ranks is possible if the platform allows it, but the system will run all modules at the lowest common speed and voltage.

How can I confirm the module is running at 2666 MHz with ECC active after installation?

Check the BIOS memory information or use a tool like CPU-Z to verify 2666 MT/s, CL19 timings, and ECC status showing enabled.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.