Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn

godream

godream DS850-3-006 850W power supply

SKU CH-75BB-EBA0H

An 850W ATX power module tested working for reliable system power

  • TypeATX
  • Tested and working for reliable operation
  • 850W output supports demanding components
  • ATX form factor fits standard cases
  • Good quality build for lasting performance

godream DS850-3-006 850W power supply

This ATX power module delivers 850W of rated output for Emerson compatible systems. It suits builders replacing a failed unit or assembling equipment that requires this specific form factor and power rating. The unit is supplied new and has been tested working by the supplier. Buyers needing a different connector layout or a higher wattage rating should verify compatibility before ordering.

Thermals, noise and power draw

Normal operation stays within the design limits of an 850W ATX supply, so case airflow handles the heat without extra measures. Fan speed ramps with load, keeping acoustic output low during typical workloads. Efficiency at usual loads reduces waste heat and keeps mains draw predictable. The module draws only the power the connected components require, up to its 850W maximum.

Helstu kostir

  • Tested and working for reliable operation
  • 850W output supports demanding components
  • ATX form factor fits standard cases
  • Good quality build for lasting performance

Tæknilýsing

TypeATX

Spurningar um þessa vöru

How is the godream DS850-3-006 installed in an Emerson chassis, and which step do people often miss?

Slide the module into the bay until the latch clicks, then tighten the captive screw; the step most often missed is securing that screw after the latch engages.

What maintenance will the DS850-3-006 need later, and which part is replaced?

Clean the intake vents every few months with compressed air; the internal fan is the only moving component that may require replacement after extended use.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.