Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Black plastic 2.5 inch SATA enclosure with USB 3.0 micro-B port, tool-free press design, LED indicator, 131mm by 80mm by 13mm

Hetai Tech

Hetai Tech 2.5″ SATA USB 3.0 Hard Drive Enclosure 6Gbps 6TB

SKU CH-R22X-QTAAB

Connects a 2.5″ SATA drive via USB 3.0 with tool-free installation, UASP support and automatic sleep to reduce wear

  • TypeEnclosure
  • Tool-free press-and-scratch design lets you swap 2.5″ SATA drives in seconds
  • USB 3.0 interface with UASP delivers up to 6 Gbps theoretical throughput
  • Automatic sleep after three idle minutes cuts power draw and reduces drive wear
  • Driver-free operation on Windows XP through 10, macOS and Linux
  • Compact 131 × 80 × 13 mm ABS shell weighs just 65 g

2.5″ SATA USB 3.0 Enclosure

This Hetai Tech enclosure turns a 2.5″ SATA hard drive or solid-state drive into an external USB 3.0 storage device. It is built for notebook owners and PC users who want to reuse an internal drive for portable backups or data transfer. The tool-free press design lets you swap drives in seconds without a screwdriver. No driver installation is required on Windows XP through 10, macOS or Linux.

6Gbps USB 3.0 with UASP

The single specification that decides fit is the USB 3.0 Micro-B interface running at a theoretical 6Gbps with UASP support. This bandwidth matches the native speed of a SATA III drive so sequential reads and writes are not bottlenecked by the bridge. The connection is backward compatible with USB 2.0 and USB 1.1 ports, though throughput will fall to those slower standards when used on older hosts.

Tool-free tray and auto sleep

The bundled press-and-slide tray removes the need for screws or cables inside the ABS shell, making drive changes truly tool-free. An intelligent sleep function spins the drive down after three minutes of inactivity, cutting power draw and reducing mechanical wear on spinning disks. An LED indicator shows power and activity status at a glance.

Helstu kostir

  • Tool-free press-and-scratch design lets you swap 2.5″ SATA drives in seconds
  • USB 3.0 interface with UASP delivers up to 6 Gbps theoretical throughput
  • Automatic sleep after three idle minutes cuts power draw and reduces drive wear
  • Driver-free operation on Windows XP through 10, macOS and Linux
  • Compact 131 × 80 × 13 mm ABS shell weighs just 65 g

Tæknilýsing

TypeEnclosure

Spurningar um þessa vöru

What real-world throughput does the 6 Gbps rating deliver when the enclosure is connected to a USB 3.0 port?

The 6 Gbps figure is the SATA link ceiling; actual sustained transfer is limited by the USB 3.0 micro-B interface and the drive you install, so typical speeds fall below the theoretical maximum.

Which USB standard does the micro-B connector use and what is the practical speed limit?

It uses USB 3.0 micro-B with UASP support, capping real-world throughput at the USB 3.0 5 Gbps signalling rate rather than the SATA 6 Gbps link speed.

What drive height and overall dimensions must a 2.5-inch SATA drive have to fit inside the 131 mm × 80 mm × 13 mm enclosure?

The enclosure accepts standard 2.5-inch SATA HDDs or SSDs up to 13 mm thick; the internal cavity matches the 131 mm length and 80 mm width of the case.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.