Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn

KEHIPI

KEHIPI 64MP Hawkeye Autofocus Camera Module development board

SKU CH-R709-HRNDJ

64MP autofocus camera module captures 9152×6944 stills and works with every Raspberry Pi board via MIPI CSI-2

  • 9152 x 6944 ultra-high resolution stills
  • Autofocus motor enables fast infinite focus
  • 10x digital zoom for closer detail
  • Compatible with every Raspberry Pi board
  • Pre-compiled program for plug-and-play use

64MP Autofocus Camera for Raspberry Pi

The KEHIPI 64MP Hawkeye module delivers 9152 x 6944 still images through a MIPI CSI-2 interface. It fits every Raspberry Pi board from the Zero to the 5 using the standard camera footprint. Makers, robotics hobbyists and edge-AI developers can add flagship-phone resolution without changing their existing carrier boards.

Sustained capture and focus behaviour

The built-in autofocus motor maintains sharpness across continuous streaming, while 10x digital zoom is handled in software without frame drops. Libcamera on Bullseye drives the sensor at full 64MP resolution for extended periods, and the pre-compiled demo program lets newcomers verify stability within minutes of first boot.

Mechanical integration and daily mounting

Identical dimensions to the official Camera Module 3 mean existing enclosures, tripod adapters and pan-tilt brackets align without modification. The flat ribbon cable routes cleanly to the CSI port, and the fixed-focus alternative is not required because the motor covers infinity to close-up in one unit.

Helstu kostir

  • 9152 x 6944 ultra-high resolution stills
  • Autofocus motor enables fast infinite focus
  • 10x digital zoom for closer detail
  • Compatible with every Raspberry Pi board
  • Pre-compiled program for plug-and-play use

Tæknilýsing

BrandArducam
Model64MP Hawkeye
Part NumberB0399

Spurningar um þessa vöru

Does the 64MP Hawkeye module run hot or draw extra power when recording continuously on a Raspberry Pi 5?

The camera draws power directly from the Raspberry Pi CSI-2 port; typical operation adds only a small load, and the board has no active cooling, so heat stays low during all-day capture.

Which Raspberry Pi boards and cables do I need before the 64MP Hawkeye will work?

Any Raspberry Pi with a MIPI CSI-2 connector — 5, 4B, 3B+, 3B, 2B, A+, Zero, Zero W or Zero WH — plus the standard ribbon cable that matches your board’s CSI port.

Will the 64MP Hawkeye autofocus motor work with the libcamera stack on Raspberry Pi OS Bullseye without extra drivers?

Yes, the module uses the standard MIPI CSI-2 interface and is supported by libcamera on Bullseye; the built-in autofocus motor is controlled through the same software stack.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.