Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Black rectangular ATX power supply unit with label showing 12V 1.2A and 12V .9A ratings

KHACHIMO

KHACHIMO WRA22FWX 12V 1.2A 0.9A power supply

SKU CH-1PAR-19Y52

Provides 12V dual-output power at 1.2A and .9A for ETA-SEI systems

  • TypeATX
  • Reliable dual-voltage output for ETA-SEI devices
  • Tested working unit ensures immediate operation
  • Good quality construction supports stable power delivery
  • 12V rails at 1.2A and .9A match original specs

ATX power supply for ETA-SEI systems

This ATX power supply delivers 12 V at 1.2 A and 12 V at 0.9 A for ETA-SEI equipment. It is built for technicians who need a direct replacement unit that has been tested and confirmed working. The supply suits repair jobs where the original WRA22FWX module has failed or is missing.

Sustained dual-rail output under load

Both 12 V rails maintain their rated currents continuously during extended operation rather than only in brief peaks. The design targets stable voltage delivery for the target hardware without added features or higher wattage headroom. It is not for builds that require greater amperage, additional voltage rails or modular cabling.

Helstu kostir

  • Reliable dual-voltage output for ETA-SEI devices
  • Tested working unit ensures immediate operation
  • Good quality construction supports stable power delivery
  • 12V rails at 1.2A and .9A match original specs

Tæknilýsing

TypeATX

Spurningar um þessa vöru

How much heat and power draw should I expect from the WRA22FWX running continuously?

The unit delivers 12 V at up to 1.2 A on one rail and 0.9 A on the other, so total output is modest and heat stays low during all-day use.

Which connectors or cables must I already have to install this ATX power supply?

You need a standard ATX 24-pin motherboard connector plus any peripheral leads your build requires; the supply itself provides the ATX interface.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.